What Rx would you recommend? About to order this plane very soon. Would really like stabilization just incase i got into trouble. Btw i have a radiomaster TX16s so it can control spektrum and most all others
@weshillsberry6275
4 ай бұрын
Never CA your gear covers to the fuesalage use some shoe goo or something and glue yhem to yhe gear. A solid CA seal can crack and rip the covering on hard landings u want some flex at the fues glued to the gear
@stephenrout9025
7 ай бұрын
hi where is ceg do we have li po as far foward as we can thanks cant find any thing about ceg
@fishing8374
7 ай бұрын
Thanks very helpful
@align1967yt
6 ай бұрын
Quick question what is the extra wire on the speed controller. And what is the other connector in the battery compartment????
@garyrice4610
6 ай бұрын
Telemetry
@stephenrout9025
7 ай бұрын
hi do you strap lipos down and velco them
@garyrice4610
7 ай бұрын
There is a velcro strip that goes inside the fuse and a strap that goes around the battery and the former inside the fuse.
@slange455
11 ай бұрын
Looks nice only thing I don’t care for is the brand name on the wing …don’t see that with other brands
@garyrice4610
11 ай бұрын
It comes pre.printed in the covering. You can buy the green one. It doesn't have logos on it.
@mabelpi2282
11 ай бұрын
Great video, hope you have fun with OMPHobby airplanes.
@tap9083
7 ай бұрын
How is the PNP version holding up. My concern was the servos, with lack of parts availability.
@garyrice4610
7 ай бұрын
30 plus flights and no problems
@garyrice4610
7 ай бұрын
30 plus flights. No problems so car. I fly it as hard as I can.
@tap9083
7 ай бұрын
@@garyrice4610 Thank you for the info.
@jimrice4270
11 ай бұрын
Can I have a Flight after I fly it? Good Job!👍🙂🇺🇸
@fishing8374
7 ай бұрын
Which wire from the speed control go to the receiver
@mattsrcking
8 ай бұрын
What glue did you use for the rudder hinges? And same for horizontal? I’m a jet guy so usually use hysol.
@theshredder9822
8 ай бұрын
I use the hysol loc tite 608 or i have used regular 2 part epoxy
@garyrice4610
11 күн бұрын
I use Bob Smith Thin CA
@tonydarst8211
11 ай бұрын
I like it. A lot!
@wjb111
9 ай бұрын
Not familiar with OMP. Any idea how they compare to Extreme Flight?
@garyrice4610
9 ай бұрын
Very light weight. Built very strong with cevlar reinforcements. As of now they only have the edge in two sizes. And a crazy airplane called the bighorn. More are coming soon.
@monchichis333
3 ай бұрын
For price value, performance, and quality, it gives extreme flight a run for their money on the 60" class. I fly mine hard and it holds up just like the extreme flight planes. I own both
@zebjacko9882
10 ай бұрын
😏 Promo-SM
@stephenrout9025
8 ай бұрын
hi whats the best colour to see in the sky as so many
@garyrice4610
7 ай бұрын
The red shows up nice. But I have heard from others the orange stands out best in the sky.
@keepondoubletruckin8466
9 ай бұрын
Thank You
@davidhall4398
10 ай бұрын
wow i cant believe you glued the landing gear pants to the fuse....if you break your landing gear you have made it impossible to replace. without damaging the covering.. normally these are just glued inside them to the gear only.
@garyrice4610
10 ай бұрын
It popped off on the third flight. I have now put them on with silicone.
@davidhall4398
10 ай бұрын
@@garyrice4610 That was lucky 👍 I've had loads of these planes 60 67in... I now don't use steel bolts to hold the landing gear on...I use 2 only M6 nylon bolts they break off nicely without damaging the fuselage extensively inside... 😉 Also I don't use steel bolts/screws on the wheel pants too...I use M3 nylon bolts screwed into captive nuts inside the pants this allows the pants to come off too... I fly off rough grass in winter but it's also handy if you have a deadstick or hard landing... 😉
Пікірлер: 31