Mike, can you do a video on how to do the offsets for the laser to the spindle?
@RockhollowCNCServices
5 ай бұрын
Great video, thanks. I just got my Jtech and getting going with it. I hope to see more of your stuff!!
@DaddyDanz
5 ай бұрын
Awesome video full of instruction Can you help with your spoil board set up I would love to have plans to duplicate it for my Onefinity elite on a own stand
@OnefinityCNC
Жыл бұрын
Great video Mike!
@8thsinner
9 ай бұрын
Still getting used to the terms and stuff here, but my air assist pump arrives this morning and I'll be setting mine up today. So it's my understanding that all the g codes there 54-60 was it...are just offset differences between stuff. But if light burn always uses g54 to probe it's start position. wouldn't it make sense to just keep that for use with laser only and then use the others for other vetric stuff like parking or what have you?
@mikebogart3841
9 ай бұрын
I suppose but Masso starts in G54 so pretty easy to forget and use it for non-laser work. Also, I do a lot of tumblers and drinkware on a rotary makes it easier if you can store an offset for each item. I’ve taken to manually deleting the G54 from the code at this point.
@nasty906
8 ай бұрын
Thank You
@captaincrunchy1290
Жыл бұрын
Is there a list of mdi commands listed anywhere? What command do I use to switch back to the router or spindle?
@mikebogart3841
Жыл бұрын
T=tool number M06=tool change.. so T1M06 would change it back to tool 1.. usually I just change back to whatever tool was in the spindle before I changed to laser. The number after T can be anything between 1-100. Some reserve tool 1 for a probe pin.
Пікірлер: 11