This helped me fix my 2004 ski doo 800ho. Thank you! I had cleaned the main jets, but didn't take out the small pilot jets that have the tiny holes on the sides. These jets were clogged, and the hole that goes through the long way is tiny. The smallest needle I had in the house wouldn't fit through to clean. I soaked in carb cleaner, blew through with air, and could finally push fishing line through when cleaned. Take your time to find the correct flat head screwdriver to remove jets, not something you want to strip out.
@saulgoodman9537
11 ай бұрын
You were just the right answer. Pressure washer was running choke open only and I cleaned it up and it runs perfect.
@julianalanyi4189
Жыл бұрын
Thank you so much! My carb rebuild kit didn't come with that particular part, so now I'll take it apart and look at that more closely.
@nameyourchannel7844
2 ай бұрын
It's called an emulsion tube. Those holes pull air through to atomize the fuel mixture. That's pretty much always the problem when having running issues, or will only run on choke. Blame ethanol for that..
@nickayivor8432
2 жыл бұрын
What do you call KNOWLEDGEABLE and SUBSTANTIAL the answer is Thomas Brian Thanks for sharing what you know with us great tutorial 👍 👌 God bless you and all your family around you Thomas Brian From Nick Ayivor from London England UK 🇬🇧
@OnToCamping
Жыл бұрын
I think you just answered one of my questions. On my engine, I cannot see through that jet you are showing, but the little side holes are clear. I wasn't sure if I should be able to see right through the jet as well (this engine sat for 7 years) I cleaned everything and fired it up and it sounds great, but would only idle with choke out. Looks like I'll take the carb off again and clean this jet so I can see through it. Thanks for the video
@sanchezjones8276
11 ай бұрын
Yooo if this work I will watch like all yr videos and subscribe
@troyhudsonsr8807
Жыл бұрын
Very informational quick to the issue,going to go try that on my Coleman mini bike thank you
@AngelRamirez24444
20 күн бұрын
Did it work?
@alexpostevka1216
Жыл бұрын
Got the same problem with my woof splitter. Will only run with the choke pulled out once I press it back in the wood splitter shuts off.
@californiadreaming9216
6 ай бұрын
THERE IS NO POINT IN CLEANING CARBURETORS UNLESS YOU THOROUGHLY CLEAN OUT THE FUEL TANK ALSO OTHERWISE CARBURETORS WILL JUST CLOG UP ALL OVER AGAIN.
@CosmicSeeker69
4 ай бұрын
you could do with a check up Bro
@anthonypeterson5618
Жыл бұрын
I dismantled and clean those holes and more. My runs rough only on choke. Might air/mix screw be off too?
@crisis-cast
Жыл бұрын
RIGHT ON. I needed this video. thank you
@peacefulscrimp5183
7 күн бұрын
You have a new subscriber 👍
@GaryFi
Ай бұрын
Nice and to the point, Thanks!
@TOAST4130
7 ай бұрын
I’m so lost I bought a new carb and it will only run with choke on doesn’t make any sense to me jets are clean not sure what else it could be
@poetthegreat4243
4 ай бұрын
Same here! Tryna see what's the problem. You found the problem?
@TOAST4130
4 ай бұрын
No I have no clue
@Tatby
4 ай бұрын
@@TOAST4130ok so I owned 5 pw 80s and all of them have this exact issue, except I fixed the issue everytime. Make sure carb is spotless, check plugs,do not mess with the injector only replace oil when needed just slight tweaks will mess up the choke on these things, make sure your bike is getting enough air flow, and triple check your filter
@Tatby
4 ай бұрын
All in all tho the choke is there for a reason, if you hop on your bike for the first time in a week and try to ride without your choke it’s gonna bog and stall, it’s gonna run like poop lol, You need to warm up the bike with choke on for a good 20-30 minutes then turn the choke off with the bike still running hot, this will basically get the bike used to running without choke, I promise if you listen to these tips your bike will run fine.
@Tatby
4 ай бұрын
@@TOAST4130also 1 more thing a few of my pw80s ran so much better with the gas put on reserved, it changes the airflow in a typa way 👍
@MrMoosekiller31
4 ай бұрын
Torch tip cleaner works great to get into those tiny holes if anyone's looking for something small enough to get in there thats what I found worked best or small guitar string but torch tip cleaners are designed for this so your best to go grab yourself a set for couple bucks 👍
@Anybodywannapeanut3
Жыл бұрын
I cleaned them as well even with a wire through every jet hole. It still only runs with the choke out . Btw it’s just a small trail master go kart carb
@redeemedmat2211
4 ай бұрын
Thanks man , mine was different but I was able to find it and clean it .
@NicoA71
2 жыл бұрын
Thanks ! That helped me out!
@choppergirl
5 ай бұрын
Yeah, did all that a million times, does not fix the problem. Want some other answer that says its something other than the idle jet being clogged, because it's not. I can fill the idle jet well with solvent and it will siv right through it. Rebuilt this thing with new parts 50 different times, putting it on and off again, with the same problem. Only runs on choke, and stumbles when you twist throttle. It's not the idle jet, pilot jet, or master jet. I replaced that whole jet with one with clean holes., and made sure fluid goes through all 3 jets.
@sonny2435
6 ай бұрын
Awesome, ! this works EVERY time !+
@stevenmorris2293
26 күн бұрын
The carburetor. Still mystifying us 100 years + on . Nobody wants to pull that mother and dismantle it , put it back together after it’s been sitting in the garage for 6 months .
@Me23-e4u
9 ай бұрын
Thank you I just purchased a 96 YZ 250 and it won’t stay running, unless the choke is on
@carltongaskins8156
Жыл бұрын
Thank you so very much, needed that info!!!🤔
@SMGPERFORMANCE16
Жыл бұрын
If this fixes my probme youll get a hug. Im fighting one with this.
@personalaccount342
6 ай бұрын
awesome vid clear and informative. Question, mine starts and runs fine, idles fine, revs up smooth and fine, but i can throttle up to 98% no issue and even hold it there still runs fine, but if i twist that 2% to throttle stop, it dies instantly i let go of the throttle keeps idling over and again,? any ideas? throttle seems clean filter clean. cheerrs
@Morbidbubba3
2 жыл бұрын
I have a 92 Polaris trailboss 350 2 stroke it gets stuck wide open when we first got it was good but the throttle was angled down and wasn't in a normal or comfortable position so I angled it where I thought it would be and that's when the problem started I've readjusted the cable I've twisted it back towards where it was to begin with but it's still sticking would you have any ideas
@paradigmshift3775
Жыл бұрын
Awesome
@PaoloFamily-pr1mo
4 ай бұрын
hey buddy, those holes at the sides, is that item supposed to have whole all the way through top to bottom? because mine is having clear side holes, but top to bottom is blocked and I cant push whatver is blocking
@alonzogracian5615
Жыл бұрын
Thanks for the video
@4kWalkingAndDrivingTours
11 ай бұрын
Cool thanks! 🤓👍🏼😎
@thomasbriansavingmoney
11 ай бұрын
You bet!
@loki48209
2 жыл бұрын
Good shit! Thanks brother!
@adropro3218
Жыл бұрын
Excellent
@FRANKLIN-vu1vn
3 ай бұрын
Put new carb on 89 kawasaki bayuo and wont run with choke off ??
@marioguzman9290
2 жыл бұрын
My 2000 YZ250 has a PWK38S carb. I was reading online that this carb has a power jet. What is a power jet? I only see two jets: the main and pilot. Thanks
@tahaafzal8244
2 ай бұрын
would this also cause a carb to leak ?
@bennypacogerrte418
2 жыл бұрын
So the ports have to be blocked by the housing wen being Inserted???
@TimmoDukes
2 жыл бұрын
Yes
@AmericanKnowmad
Жыл бұрын
Bet you are correct sir
@vstrom9586
Жыл бұрын
Thank you for sharing
@adamr8628
Жыл бұрын
On my 2001 500 HO I choke it in cold weather and have to hold the throttle a little while it warms up to keep it running. Once it warms up it idles and runs fine. The idle is almost on the high side when warmed up. But when cold the idle seems low. Does anyone know what that issue is?
@alandoyle6416
Жыл бұрын
👍
@jonathanhurst5904
7 ай бұрын
I cleaned that and my bike will still on run with carb on. Second I turn it off it dies
@cmason5203
10 ай бұрын
thank you!!!!!!
@CosmicSeeker69
4 ай бұрын
IF ONLY it was that simple........................
@Kevin_Yagoonie
Жыл бұрын
What about if it runs and idles but dies when revved up and will only rev up with choke
@agcobileboqwana9923
Жыл бұрын
🙆🏽♂️ Did you find any solution my brother? My 250 Buggy has been driving me nuts😔
@Kevin_Yagoonie
Жыл бұрын
@@agcobileboqwana9923 I cleaned out the carb and did a total carb rebuild and jet kit. Also replace the carb to intake boots because they had rips in it. Runs mint now. So it must of been one of them issues.
@agcobileboqwana9923
Жыл бұрын
Thanks Bro, i'll definitely try that🙏🏼
@Fieldyfan94
Жыл бұрын
@@Kevin_Yagooniehey I just got a 82 xl500r today and it has the exact problem what should I do?
@kolegibson1723
Жыл бұрын
Not it what else could it be
@GordonChristie
19 күн бұрын
if anythin looks green give it a clean
@Charlieols
Жыл бұрын
Did anyone have success with this?
@lilbroly6669
Жыл бұрын
Clean this n bike still only runs on choke
@kolegibson1723
Жыл бұрын
Same
@lilbroly6669
Жыл бұрын
@@FAKE-NAME well my carb got fucked so I'm finna try a aftermarket one
Пікірлер: 69