You actually can overlap the arrows if you check Apply per instance.
@Grze9898
2 ай бұрын
Thanks, I done my work thanks to this video.
@SlinksterOne
11 ай бұрын
Thanks exactly what I was looking for! Cheers
@CarlRydell-m4c
6 ай бұрын
Thanks, helpful video
@aidanearl
4 ай бұрын
Very informative. Thanks.
@littlehills739
4 ай бұрын
thanks you this helps
@littlehills739
4 ай бұрын
7:49 to over come the red extend the part longer then u need wrap it then click on the end and extrude - remove bk to the length u wanted ?
@cstahhh
4 ай бұрын
Great video! Concise and easy to follow. Thanks!
@theycallme_nightmaster
6 ай бұрын
damn needed to do this but the surface isn't perfectly cylindrical (even though it has consistent curvature) so the wrap tool doesn't work
@Alfredworks
6 ай бұрын
You could try to extrude in the direction of the cylinder with a draft or just extrude down to the surface and then extrude a removing cylinder. If any of that makes sense. Good luck
@theycallme_nightmaster
6 ай бұрын
@@Alfredworks I ended up just extruding down from a plane up to surface with an offset for my cut depth. Obviously it doesn't really "wrap" preserving the dimensions of the sketch but it worked well enough for what I was doing. Thanks for the vid+draft idea that's good
Пікірлер: 11