On the cam pulley my vehicle has two notches 180 degrees apart. One notch is at 12 o'clock and the other at 6 o'clock. Which one would be correct? There is a corresponding A & B mark for each of the two.
@fdr1895
Жыл бұрын
Cool... You make it seem like a piece of cake 🤘🤞
@mkautotech4440
Жыл бұрын
Thanks
@christshivhase8772
4 ай бұрын
Hi after lining the top mark and bottom mark do i put the screw driver on plug no 1 and turn the engine until the screw driver goes up
@user-qp2fn3pr5q
Ай бұрын
Can you please show me how to set timing on a 4EE2 Isuzu diesel for opel corsa
@AlesJezek-xw7po
6 ай бұрын
Super labombastic fantastic skolastic💘
@mkautotech4440
6 ай бұрын
Thanks
@archiefordsikoti5848
2 жыл бұрын
My car does not have a notch on the cover how do i set the right timing.
@mkautotech4440
2 жыл бұрын
thanks for you question. if you dont have the cover you can open the tappet cover and rotate the engine until both camshaft lobes one cylinder number 1 face upward. hope this helps
@LunganiMemo
10 ай бұрын
Replaced the tensioner in my car... I can't seem to get the belt tight enough... Do you have any video explaining how to make the belt tight using the tensioner
@mkautotech4440
10 ай бұрын
Good evening sir, I currently don't have the video , but I can explain to you how to tighten it. On your water pump there are 3 Allen key bolts that tighten the water pump to the bolt, loosen then using 5mm Allen key , then if you check behind the water pump pulley there is a space to use 36mm spanner or so , using that spanner adjust the water pump until the belt is tight. If it's tight enough , tighten the three Allen bolts , . Hope this will help man
@mkautotech4440
10 ай бұрын
The bolts tighten the water pump to the block
@luxeltondo
Жыл бұрын
Thank you so much 🙏
@mkautotech4440
Жыл бұрын
You're welcome 😊
@huwandavids8407
2 жыл бұрын
hey man 🖐 great video!! i have a question tho, wot do i do if the timing is set correct but throws it out wen driving? the ping is quite bad wen the car is hot or running temp. 🙏🙏🙏
@mkautotech4440
2 жыл бұрын
make sure the belt tension is good, otherwise you will have to loosen the water pump and adjust it
Пікірлер: 21