I have a lot of free time on my hands, so I've been playing with OpenFOAM and Blender and etc.
This is the buckling analysis Vol01 simulation of the juice can.
I confirmed the analysis when buckling an aluminum can with PrePoMax.
Unfortunately, I was unable to perform buckling analysis on the top of the can, but I will continue to verify this.
Oops, regarding the result display in PrePoMax, I understand why the contour display color does not change.
Chapters:
00:00 ①Front cover
00:00 ②Schematic diagram and description.
00:20 ③PrePoMax results are displayed.
Note: Basically, I don't disclose the analysis conditions (boundary conditions, etc.) of OpenFOAM
【If you like this video, please like, share, and subscribe to my channel. 】
もの凄く暇を持て余しているのでOpenFOAM等で遊んでいます.
今回はジュース缶の座屈解析Vol01シュミレーションです。
PrePoMaxでアルミ缶を潰したときの解析を確認致しました。
缶最上部の座屈解析が行えなかったのが残念ですが、引き続き検証致します。
おっと、PrePoMaxでの結果表示ですが、コンター表示色の色が変化しない理由は解っています。
注意事項: 基本的にOpenFOAMの解析条件(境界条件等々)は開示しておりません。
【もしこの動画が気に入ったら、いいね、シェア、チャンネル登録をお願いします。】
#openfoam #blender #paraview #xsim #freecad #fem #cfd #tutorial #denka #prepomax #デンカ #流体 #buckling #simulation #opensource #CAE #cad #opensource #FEM #analysis #feanalysis #prepomax #calculix #design #structuralanalysis #thermalanalyis #tutorial #engineering #simulation #caesoftware #computeraideddesign #ngsolve #opencascade #meshing #preprocessing #postprocessing #dynamicanalysis #elasticity #plasticity #nonlinearanalysis #nonlinear
Негізгі бет Ғылым және технология OpenFOAM & Blender : Buckling Vol.01 Simulation
Пікірлер