I have a lot of free time on my hands, so I've been playing with OpenFOAM and Blender and etc.
This is a simulation of gear Vol01.
I confirmed the contact analysis of two gears and two types of plates using PrePoMax.
The difficult part was deciding between static analysis and dynamic analysis.
I thought that dynamic analysis would be preferable because it includes not only the gears but also the operation of the Balance plate, but the settings did not go well. In the end, we decided to use static analysis.
Based on the above, if you have any good advice, please leave a comment.
Chapters:
00:00 ①Front cover
00:00 ②Schematic diagram and description.
00:40 ③PrePoMax results are displayed.
Note: Basically, I don't disclose the analysis conditions (boundary conditions, etc.) of OpenFOAM
【If you like this video, please like, share, and subscribe to my channel. 】
もの凄く暇を持て余しているのでOpenFOAM等で遊んでいます.
今回は歯車Vol01のシュミレーションです。
2枚の歯車、2種類の板の接触解析をPrePoMaxで確認致しました。
難しかったのは静的解析と動的解析の判断でした。歯車だけでなくテンプの動作が含まれるため、動的解析が好ましいと考えたのですが設定が
上手くいかず。最終的に静的解析で行う事としました。
以上を踏まえ、良いアドバイスがあればコメントして下さい。
注意事項: 基本的にOpenFOAMの解析条件(境界条件等々)は開示しておりません。
【もしこの動画が気に入ったら、いいね、シェア、チャンネル登録をお願いします。】
#openfoam #blender #paraview #xsim #freecad #fem #cfd #tutorial #denka #prepomax #デンカ #流体 #gears #simulation #opensource #CAE #cad #opensource #FEM #analysis #feanalysis #prepomax #calculix #design #structuralanalysis #thermalanalyis #tutorial #engineering #simulation #caesoftware #computeraideddesign #ngsolve #opencascade #meshing #preprocessing #postprocessing #dynamicanalysis #elasticity #plasticity #nonlinearanalysis #nonlinear
Негізгі бет Ғылым және технология OpenFOAM & Blender : Gears Vol.01 Simulation
Пікірлер: 6