Can you get data, such as cD on vehicles using Blender and OPENfoam ? Are you using Blender as a U.I. for OPENfoam ? It appears as though FreeCAD has a way of being able to run OPENfoam using the FreeCAD U.I.
@take_den_openfoam
4 ай бұрын
Thank you for sending your comment. Now, regarding your three questions, I am worried about answering them correctly as I have been using OpenFOAM for two years and structural analysis for about a year. I would appreciate it if you could consider that this is just my personal opinion. Are you talking about CFD? If you are interested in CFD for cars, I offer a few things like the video below. kzitem.info/news/bejne/lmyol5uLcXyqqKg However, my PC environment is very poor, so the performance is not the best. It is possible to use it for aerodynamic analysis of the car in your video that has a special device at the rear, but unfortunately the results will not be good. Blender is great software and I use it for KZitem explanations, but unfortunately it doesn't work well with OpenFOAM. Therefore, the UI for OpenFOAM uses FreeCAD. At first glance, the CFD video of the car that I answered earlier may look like it was output using Blender, but that is not the case. It's about cfdOF. FreeCAD is also a wonderful software, and I use it not only to create models but also to perform structural analysis. However, unlike Blender etc., FreeCAD cannot be operated intuitively, so it is too difficult for someone like me who has no training in fluid analysis or structural analysis. As a result, I tried cfdOF, but it didn't go well.
@O-cDxA
4 ай бұрын
@@take_den_openfoam Thank you for your reply ! Regarding what I am interested in doing C.F.D. for, yes, I would like to do testing on my car modifications.
@take_den_openfoam
4 ай бұрын
@@O-cDxA I hope your endeavors are successful.
@take_den_openfoam
4 ай бұрын
I don't think it will work out the way you want, but I will try to analyze it with a similar shape.
Пікірлер: 5