will the back housing from a non LED light work for a light with the LED model?
@lannieschafroth6814
3 жыл бұрын
How do you take apart the pieces on the headlight you set aside? Thats the part I need apart so I can paint it.
@JulienRoy-hf9kt
7 ай бұрын
Have you ever opened 2020 Silverado halogen headlights from a Custom trim? Just wondering if it can be done, thanks for any info!
@LightwerkzGlobal
7 ай бұрын
Yes, it can be opened up the same way. This method works for any light but some are tougher than others. Last resort is cutting the lens off and reattaching when done.
@JulienRoy-hf9kt
7 ай бұрын
Alright, thank you very much for your reply, it is much appreciated!
@Lb7_Danny
Жыл бұрын
Any downsides to baking them this hot for this long? Little bit scary to think about. Does it weaken anything?
@LightwerkzGlobal
Жыл бұрын
If the temp is proper and the heating elements aren't close to the lens, the risk is very minimal. But plenty of people have melted lights in the oven from not pre-heating their own or there was some sort of malfunction. Do this are your own risk.
@Jacoobczyk
4 жыл бұрын
what type of oven are you using?
@keeganmccue9755
3 жыл бұрын
Getting ready to do my switchbacks. Is it alright to leave all the wires on the back or take em off?
@LightwerkzGlobal
3 жыл бұрын
Totally fine.
@keeganmccue9755
3 жыл бұрын
@@LightwerkzGlobal thank you!
@tonyboy9826
Жыл бұрын
We’re can I buy the plastic cover
@LightwerkzGlobal
Жыл бұрын
Check ebay or Alibaba. I only see lenses for 07-13 model year though.
@RioPetersen
3 жыл бұрын
I did this same technique with my 2017 Ford Focus headlights and the sealer is still rock hard, I put it in the oven for 20-minute intervals at 275º and the sealer is still stiff, I repeated this process for 2 hours. What can I do?
@LightwerkzGlobal
3 жыл бұрын
Try a pick with an a right angle or a set of cold glue tools to slice them open lightwerkz.net/products/cold-glue-tool-set?_pos=1&_sid=95cb1793a&_ss=r
@ryan7868
2 жыл бұрын
That last edge is tricky alright I broke a lense because I got a little impatient and wasn't really pulling it out sideways. My other headlight I found after 240° for 15 minutes I went around the whole headlight with a flathead and got between the permaseal then another 15 minutes in the oven again and it came right apart. Thanks Caesar!
@LightwerkzGlobal
2 жыл бұрын
Second one always easier!
@WickedWarnings
4 жыл бұрын
Why the mask in your own shop?
@DoctorRickSanchez
Жыл бұрын
Why worry about it?
@danhaines
4 жыл бұрын
Hi, what are the spreader tools you use?
@jckgoldness
4 жыл бұрын
bruh I swear i looked in HomeDepot and Ace and nobody knew what I was talking about lol
Пікірлер: 25