The "oscillator trigger off" function typically refers to a feature in electronic oscillators, particularly in digital signal processing and synthesizers. Essentially, it's a function that controls when the oscillator starts or stops generating a waveform based on an external trigger signal. This function allows precise timing and synchronization of the oscillator's output with other components or events in a system.
@niroshperera9847
3 ай бұрын
Trigger holdoff is an adjustable period of time during which the digitizer cannot trigger. NI high-speed digitizers use trigger holdoff to guarantee a minimum time between two Reference Triggers.
@ChathuraJayasundaraIMD
3 ай бұрын
Oscilloscope එකේ trigger එකක් වෙලා ආයෙ trigger condition check කරන්න පටන් ගන්න කලින් පොඩ්ඩක් නිකන් හිටපන් කියල අපි oscilloscope එකට දෙන time duration එක තමයි holdoff එක කියන්නේ. 😊 Video එක පට්ට sir! Please share more knowledge like this!
The holdoff function in an oscilloscope is used to prevent the triggering circuit from re-arming immediately after a trigger event. This function adds a delay before the oscilloscope can trigger again, which can be useful for capturing complex or repetitive signals without triggering on unwanted events. It helps to ensure that the oscilloscope only captures the desired signal by allowing the user to set a minimum time interval before the oscilloscope can trigger again, ignoring any trigger events that occur during that time.
hantek digital oscilloscope eka hodaida ntnm standard ekkma gnna ek hodada
@dilshan1971
3 ай бұрын
Hantek එක හොඳයි..
@sarathjayakodi2962
3 ай бұрын
දන්නෑ Kesbewa
@startupideajournal
3 ай бұрын
The comparison for multimeter and oscilloscope is not entirely correct. In fact, you can measure the current using an oscilloscope without an expensive current probe using a shunt resistor (just like the mechanism used by a multimeter). Of course this requires a ohm's law calculation to calculate the voltage, but modern oscilloscopes already have functions to set the reading to amperes. Similarly resistance and capacitance can also be measured indirectly, in fact the used oscilloscope that I have Beckman Industrial 9020 20Mhz, comes with a COMP Test, which can test diodes and resistors/continuity, by generating the IV characteristic waveform.
Пікірлер: 135