Walk test on these panels has to be programmed as a service group. They don't come standard with it.
@luanduong9708
2 жыл бұрын
I'm in Vietnam, I don't know if this line control needs a key to set it up or not?
@Dave-ji1hv
3 жыл бұрын
I'm hoping you can help me out. I'm trying to program a QS1 with a serial cable. I made sure the wiring was correct, I followed the manual and verified with a continuity tester. It's a 1.8 version but I'm programming it with 2.5 since I heard it is supposed to work. I'm using the serial connector on my laptop (Com1) and trying to read the database but it gives "an error has occurred" and it tells me to retry. When I try to transmit a database to the panel, it gives me an error "failed to autobaud". Could it be the software as the problem or is it something else?
@canadianalarms
3 жыл бұрын
I would try the 1.8 program to get the program off the panel and then use code loader to update the panel to 2.5 and if you can transfer the file to the 2.5 program but I have not tried this so do this on your own caution. But do save that 1.8 file keep it safe.
@Dave-ji1hv
3 жыл бұрын
@@canadianalarms Ok so I tried to read the database with 1.8 as well and it gave me errors too. I'm certain the cable is right since it's just a serial cable with the end chopped off, I verified it's making good contact with the connections on the panel. What should the baud rate be set to?
Пікірлер: 8