Painting and Finishing a V-Carved Project
More down here ↓↓↓ Click SHOW MORE!
In this video, I’ll demonstrate how I paint and finish a v-carved project.
A lot of this goes back to standard woodworking. I use normal sanding, sealing, painting, and finishing techniques. I’ll go over it all step-by-step.
I’ll also show you how I clamp the project to my Gatton CNC and cut a horizontal keyhole slot in the back of the project.
As usual, if you have any comments or questions about anything I covered in this video, please put ‘em in the comment section below.
Link to Part 1 of this video series, Importing Files from Other Sources: • Importing CRV Files Fr...
Link to the file used to make the project in this video. You must be logged into your V&Co account to download the file, but it is a FREE project: bit.ly/2Mj3ZtR
Thanks for watching!
For more info on a Gatton CNC kit of your own, check out Dave Gatton’s Home Page at:
www.davegatton....
Links to tools and products used in this video:
Triple Edge Finder 3-Way Touch Plate: www.themakersgu...
Horizontal Toggle Clamps: amzn.to/30Id41x
Bosch 3/8 inch Keyhole Bit: amzn.to/2QjGRcc
(Alternate) Whiteside 3/8 inch Keyhole Bit : amzn.to/2HzONDn
Duster Brush: amzn.to/2EwPn2P
Minwax Clear Satin Aerosol Lacquer: amzn.to/2MgbyRk
Sherwin Williams Paint Color Samples: low.es/2VHjiv3
Some links may be affiliate or sponsor links. Purchasing or even clicking through these links will help support me and the content I provide for free.
Thank you very much for your support!
Get your Official Mark Lindsay CNC T-shirts and coffee mugs here:
marklindsaycnc....
I’m a proud founding member of the Maker’s Media Network.
Come check us out at: makersmedianetw...
marklindsaycnc.com is sponsored by Harneal Media - a website developing company that specializes in websites for the maker community. Find out more at:
harnealmedia.com/
For more information on, or to download a free trial of Cut 2D, VCarve, or Aspire, visit the Vectric website at:
www.vectric.com/
This video is for informational and entertainment purposes only.
#VCarve #Painting #Beginner
Негізгі бет Paint and Finish a V Carved Project - CNC For Beginners
No video
Пікірлер: 136