Thanks for all you do for the 3D printing community!
@GregsMakerCorner
Жыл бұрын
Wow, thank you so much!! I really appreciate the comment and support!! :)
@psmithrpm
Жыл бұрын
This is great, thank you for your contributions on the 0.2 project. I have a couple of minor suggestions: 1. Label each of your KZitem postings with a sequential number to make it easier to follow them in order (more of an issue as the videos accumulate), and 2. Outline the differences between 0.1 and 0.2. Many of us will already have built a 0.1, and being aware of the differences would help in following your tutorial. Thank you again, great job (as always)!
@GregsMakerCorner
Жыл бұрын
Great ideas! I will keep that in mind for the next videos, great idea with the number and naming. Thanks for the comment and watching. I was thinking about the difference video as well- thinking about that after I get a bit more printing time on it, hopefully in a few weeks. Thanks again!
@Orselonn
Жыл бұрын
Greg, I love your videos and will use them as a reference when upgrading from V0.1 to V0.2. Just one thing, to align the rails, it is recommended to use 2 alignment pieces, one at each end so that it does not move, with only one you do not ensure that the rail is centered.
@GregsMakerCorner
Жыл бұрын
Yes that is a great call out! I totally forgot about the rail alignment tool. I even had it printed… :) it is a good way to go for ensuring alignment.
@BobCollins42
8 ай бұрын
What black tape are you using?
@GregsMakerCorner
8 ай бұрын
Great question! I am just using run of the mill black electrical tape in the video. Using the rail stoppers to hold the carriage on is a better way to do it, but tape will work in a pinch like I show. Masking tape would probably be a better since it won't leave any gunk like the black electrical tape might.
Пікірлер: 9