Continuing on from Part 1....... I now show you how to power the compressor from the hex Ezcan, with a cable directly from the hex to the compressor, thereby doing away with the need to fit the wiring loom which used the bikes battery to power the compressor via a relay.
A small amount of soldering was needed to adapt the new cable.
Panels off, hardware mounting and cable running etc and refitting panels, should now take about 1 hour not the 1.30-2 hours needed for the wiring loom connecting the bikes battery to power the compressor.
00:00 Introduction
03:57 Putting a new 3 pin plug on the new harness
07:32 Routing the new harness
07:45 configuring the hex ezcan with the SoundBomb
09:25 Testing the horn/soundbomb
10:08 Final thoughts and any tips.
Part 1 full installation with wiring loom which is not needed with the hex ezcan
• Part 1. Full installat...
Sound bomb kit for the BMW R1250GS with adaptive headlight supplied by Nippy Normans, £99
www.nippynormans.com/denali/b...
Denali Wiring Adapter - Sound Bomb to Hex ezCAN £15
www.nippynormans.com/r1250rt-...
3 pin connector female plug available from Nippy Normans, £6:
www.nippynormans.com/spotligh...
Instructions are available, of sorts! find them at the Denali website:
d1l4i7f87txqmq.cloudfront.net...
Негізгі бет Ойын-сауық Part 2 Denali SoundBomb split installation, BMW R1250GS, now powered with the Hex EzCan
Пікірлер: 35