Part -3 of the rebuilding and repairs to the Heathkit 2060A deluxe
2 KW Antenna tuner ... The SWR/Switch box on the back had very loose hardware on the wide copper silver plated connecting strips .
One nut was completely loose and about to fall off one of of the 6/32 threaded rods These nuts and threaded rods appeared to be of zinc plated steel and perhaps they could be soldered to the strips
This video shows the result Yes ! they are now soldered to the strips so they will not work loose . Basically all of the nuts and bolts on this antenna tuner are very loose some just finger tight
others fell off . This was a common problem encountered in the Heathkit Amateur radio service department . Number one problem was poor soldering ,number two was loose hardware and number 3 was parts installed wrong or the wrong part installed . This video also shows installation of flexible shaft couplings and drilling of two tiny holes in the back which allows the capacitors shafts to be properly adjusted without disassembly of the tuner . 73 Bob N8RS
Негізгі бет Part-3 Heathkit Deluxe Antenna tuner SA2060A , Heathkit tuner repair.
No video
Пікірлер: 10