Because it is difficult to achieve a seal between the channels in rotors. Maybe I am wrong. Time will tell.
@TheMinimivic
Ай бұрын
@@valeriymatselevitch7660 on my 1/6 excavator I was toying with using a 20l per minute off the shelf block, which would be similar to your new design in size. What hoses and fittings are you using? Thanks for the reply, your videos have e helped me on my journey.
@valeriymatselevitch7660
Ай бұрын
@@TheMinimivic On my new valve control I use a homemade banjo fitting. The lines are 8mm OD soft copper tubing. The hoses are 8mm OD x 6MM ID Polyurethane PU Tube
@valeriymatselevitch7660
Ай бұрын
I also wanted to put a ready-made block, but I did not find a small size for 5 valves@@TheMinimivic
Пікірлер: 7