Well done thx for your informative video. I think the anti tilt is my problem and I’ll fix it tomorrow . I was going to throw it out, but now I understand how I can fix it.
@boyd1321
3 жыл бұрын
Man... THANK YOU!! I nearly beat my brains out trying to troubleshoot this, but within 10 minutes of watching your video, I had the tilt switch bypassed, and I’m back in business!
@davidschaber2121
Жыл бұрын
This was the easiest and quickest way to figure out the problem with my heater without damaging any of the equipment or wires.
@hoolie2000
10 ай бұрын
Mine was the gas tube, full of black gunk. Used an air gun and blew it all out, heater works perfectly once again. Thanks for the vid.
@aesperling
3 жыл бұрын
i temporarily bypassed mine, just like this and it works great. have ordered a new tilt switch and will replace once I get it...
@ClarenceMcIntosh-ym2pl
Жыл бұрын
This was an exact replacement for the old one that lasted about 10 years. kzitem.infoUgkx7yWIKcrbA9KMHkGSfcgxW2lsjHT6B8Sh The top of my mitigation tube by my roofline was just a 90 elbow which allowed too much debris to fall down into the fan, eventually ruining it. Without this issue, I bet it would have kept running another 10 years. When I replaced this fan, I added an extra elbow joint so the top tube now it does a 180, which should solve that problem. The radon guys around here wanted to charge me a $300 diagnostic fee, then parts/labor (probably close to $600 total). I installed this all by myself in about an hour for the cost of the fan; it would probably be even easier/faster with two people. FYI the manufacturer's warranty greatly differs depending on whether you install it yourself (1 yr warranty) or have a licensed installer do it (10 yrs).
@atimko123
2 жыл бұрын
OMG...if would have watched this first I would have saved 3hrs of my precious weekend...it worked!! 😊
@jpend98
Жыл бұрын
This was a huge help, your comment about the tilt switch lead us to a broken connection!! Thank you!
@colonelferret
6 ай бұрын
It was my tilt sensor. You're the man
@chandraholloman7120
2 жыл бұрын
Great job and I'm glad you spoke about the importance of safety by using gloves and the importance of the tilt switch. People are forgetting that the tilt switch and the thermocouple are connected. Thanks you for a safety 1st video
@rajivparikh8765
Жыл бұрын
Thank you! For me, cleaning the pilot did the trick. I order a couple of tilt switches just in case.
@craigmeisner1000
Жыл бұрын
Perfect instructions and I just ordered the part from Amazon. By hot wiring to TEST if it was the tip switch was great advice. Thank you for making this video
@bluetacster
3 жыл бұрын
Just figured out myself it is the tilt switch that's done on my heater. It's grand to have these kind of educational videos ready on the web, rather that havin people watching people play some stupid shite game. Thanks for the video!
@toddgluther
8 ай бұрын
Thanks for this video. The dump switch on my unit also went bad. This saved me a lot of time. Merry Christmas.
@pepeluva1
Жыл бұрын
Great bro. It help me a lot. I did the same as you, removed the DUMP SWITCH and the problen fixed Thank you very much
@martywouters5266
2 ай бұрын
thank you I fiddled with this heater for couple hrs back at it tommorow with some good ideas tyty
@n1av337
3 жыл бұрын
Perfect! My heater is back operational again now (bypassed the tilt switch). Thanks for taking the time to post this.
@makeshift202
2 жыл бұрын
Thanks mate for the info. It's winter on the east coast of Australia at the moment. I shorted the 2 wires on the tilt switch (exactly the same switch as your video) and heater is now staying lit. Last night we jammed an empty beer can between the control knob and a table to keep it going. Don't need to now. Our heater is much shorter so minimal chance of being knocked over. Cheers :)
@jessekoch3480
2 жыл бұрын
Same situation bloody freezing here in Victoria.
@jamesbcoats4086
3 жыл бұрын
Bypassing the tilt switch is dangerous. You DO NOT need to buy a new tilt switch. All it has in it is a ball bearing, a small strip of metal that the ball hits against and pressed against a button that cuts the circuit. The small strip of metal has a round piece of plastic that the ball hits when tilted. That piece of plastic can get hung. Give the tilt sensor a couple taps to see if it releases. If not, carefully pull it apart, which will release it. Press on the plastic that the ball presses against and make sure the button at the other end of the metal strip is going on and out. Real easy fix without sacrificing safety.
@dogwoodspringsoutdoors
3 жыл бұрын
Thanks B C. I have not disassembled a tilt switch before, but if I have this problem again I’ll certainly try your suggestion. Hopefully the new switch will last a while before that is needed. Take care!
@miltonjasso5843
7 ай бұрын
Great comment on this topic, Do you know how to fix the small flame 🔥? ?? Mine does not heat up or not light up high enough like it used to
@ernestlefebvre563
3 жыл бұрын
Thanks for this as I was able to revive our patio heater that had a clogged pilot tube. Works well now.
@ronwillcox8735
2 жыл бұрын
IM FROM ENGLAND AND I COULDNT STOP LAUGHING AT THE FORREST GUMP ACCENT SORRY BUT IT TICKED ME PINK GREAT VIDEO THOUGH THANKS
@danielaydelott2849
Жыл бұрын
Yep-Exactly what was wrong with it!!! Mine came with the defective switch from the store. Crammed a wire across and good as new! Thanks!
@chrisray8498
3 жыл бұрын
Awesome! I kept looking everywhere for this issue and the fix. Thanks!
@gregdeveer803
3 жыл бұрын
Yessss! This did it! Cleaning the pilot tube got the pilot working again but it would not stay on. Bypassed the tilt switch and now it's working again. THANKS!
@tala12
9 ай бұрын
Same problem on mine change that switch and worked perfectly
@andrewthompson9101
3 жыл бұрын
thank you so much from the UK!
@ronaldgarcia8462
3 жыл бұрын
Fantastic job explaining all the details, much appreciated. Thank you for sharing the knowledge.
@wadeblair2615
2 жыл бұрын
Genius! Bypassed the tip sensor and bingo! Thank you!
@jimkohring9694
2 жыл бұрын
This is a great explanation and just what I needed to get my patio heater going again. Isolating the tilt switch as recommended solved the problem. I also took apart tilt switch as someone else recommended but a replacement is still required. The cheap failed microswitch is the culprit. BTW, disregard the humoured, arrogant and opinionated UK guy who obviously thinks his version of English is superior to yours and likely others. Best regards from Down Under.
@dogwoodspringsoutdoors
2 жыл бұрын
Glad to hear it helped, and many thanks for taking the time to comment and for your encouragement. Take care!
@tracyligon2914
2 жыл бұрын
Just an easy way to check the tip switch! Unplug the two wires, slip the plastic covers back just a small amount and slide the two ends together using opposite sides of the slip on connectors. (They will connect easily when two of the four rounded overlays are slipped together!) If your unit now works and lights you know the switch is the problem.
@ajmee9664
3 жыл бұрын
Thank you - just fixed my Amazon Basics tower patio heater
@mattwaters6987
3 ай бұрын
Great video and fix. 👍👏
@clgrm1
3 жыл бұрын
Nice work...I'll have a go tomorrow....btw you should do voiceover work ...you've got a great accent !!!
@keitha.9788
2 жыл бұрын
The thermocouple produces a very low voltage (typically less than 20 millivolts) and current which activates the gas safety valve. The problem is that quite often the tilt switch (sometimes called a dump switch) has contacts that get a little corroded and increase the contact resistance just enough so that the gas safety valve doesn't operate.
@EmilyG12333
2 жыл бұрын
This was a huge help, thank you
@j.varsoke7937
3 жыл бұрын
If the pilot light stays lit, but feeding it full gas results in no audible gas flow, then this is likely your problem. Often you can flip the connectors and marry them to bypass the mercury switch. Obviously, you've just disabled an important safety measure, but it's good for confirming which part needs replacing.
@frodogg9379
3 жыл бұрын
Thank you, you did fix my heater 🔥..I did do the bypass and im leaving it like that... The main thing is to cut the gas every time your not using it. My hearer in on a 4 stand..not easy to push over. Again thanks for the video
@dogwoodspringsoutdoors
3 жыл бұрын
Glad you were able to get yours working. I threw my old switch away once I got a new one so I couldn’t try it myself, but in his comment on here B C says how you can fix the old switch.
@frodogg9379
3 жыл бұрын
@@dogwoodspringsoutdoors I did read that reply... it just didn't go back together in the same way...but I was good. Im fine with this set up.
@saurid72
Жыл бұрын
Thankyou this worked instantly
@eustaquiodurazo7102
2 жыл бұрын
Thank you.very helpful information.
@andrewgiancola4928
2 жыл бұрын
Thank you for this video!
@virgilalvarado7187
7 ай бұрын
You can run a wire down the heater tie it to something heavy so when it falls it yanks out the attached rigged wire .
@richardl3317
3 жыл бұрын
Great help, thanks for posting this video.
@tyjacc5
2 жыл бұрын
Awesome, I was having the same problem and this was helpful
@bassrvr1
3 жыл бұрын
Many thanks....worked like a charm.
@khanjones9390
2 жыл бұрын
Will check it out, cheers from Australia!
@diesnuts2011
2 жыл бұрын
Thanks a lot ! It was my switch too. I subscribed
@tynurse9221
2 жыл бұрын
Good Job Man Thanks !!!
@jnlambright
Жыл бұрын
That did it! Thanks.
@ardell50
2 жыл бұрын
FYI, The jumper wire not only bypassed the tilt switch it also bypassed the thermocouple.
@jimzeleny7213
2 жыл бұрын
One other thing to remember is that when the gas is first turned on after a repair or when changing tanks, the propane has to bleed through the tiny pilot orifice before it can ignite. Might take a minute or two and then will fire up.
@rubenrivas5628
2 жыл бұрын
Español
@foowinoutdoorchoice1326
3 жыл бұрын
May I ask if you can publish a heater assembly video for us, and we will provide remuneration. Looking forward to your reply
@coreybush7427
Жыл бұрын
I tried all of those things and it still will not light. How can I check if the regular is bad?
@kmroyston
10 ай бұрын
Can you share the link to your Amazon purchase? I have the same heater but see a few different kinds
@dogwoodspringsoutdoors
10 ай бұрын
Yes, sorry for the delay. If you haven't already gotten one, what I bought was a 2-pack: a.co/d/jaEnHyS
@dewhittjames
3 жыл бұрын
I'm looking for a parts house that I can get a Thermocoupler from? Brand of heater is Inferno I'm in Austin TX, yes it gets cold down here sometimes. 32* out there right now. Mamma's cold out there and I hate starting from scratch and a cold start.
@dogwoodspringsoutdoors
3 жыл бұрын
Sorry I don’t have any experience with Inferno. Maybe someone who sees this can offer some suggestions. In my case I just pulled the part number from the old one and searched that on Google. Found what I needed on Amazon. Hope you find what you need so mamma can stay warm.
@ReefMimic
Жыл бұрын
I bypassed mine and it still wont stay lit
@jerm4336
3 жыл бұрын
Need to start manufacturing quality USA again.
@rubenrivas5628
2 жыл бұрын
Traducción en español
@nickt.2825
2 жыл бұрын
To take apart the kill switch and fix. kzitem.info/news/bejne/o4yjt36YepOpZno
@jerm4336
3 жыл бұрын
Junk. All junk. I have bypassed all my tipover switches that have failed. Junk. Chinese junk.
@herschelarnow1404
3 жыл бұрын
good video but he talks to much
@methus57
3 жыл бұрын
I disagree. he was concise & explained things clearly
@tel105video
3 жыл бұрын
I don't think he talks too much. He seems like a really nice guy that is helping folks.
@timbarnhill2712
Жыл бұрын
Always one in a crowd....
@ryszardjacekrusniak7993
Жыл бұрын
Thank you...
@thepatioheatdirector1957
Жыл бұрын
Add to your round top dome patio heater by installing The Patio Heat Director Adjustable Movement Reflector : www.amazon.com/REFLECTOR-ADJUSTABLE-Heat-Directional-Patio/dp/B08JYRP5HN/ref=sr_1_15?crid=1ISYXVOLEY6SD&keywords=patio+heater+reflector+shield&qid=1662774105&sprefix=%2Caps%2C160&sr=8-15
Пікірлер: 74