Yown! 💯.. Iba tlaga pgka my experience.. Salamat sa tips master
@fidodidotech2789
Жыл бұрын
welcome po
@jetroompoc3736
Жыл бұрын
Done subscribe master... Nakit, an raku Tika kadugayan dri hehe
@fidodidotech2789
Жыл бұрын
hehehe salamat
@antoniusriyanto1120
10 ай бұрын
Everytime I turn on the amp for the first time, it comes sound 'duk' at speaker, when I turn off and turn on again, the sound is disappeared, what is the problem ? can you give me any suggestion
@alberttolentino4214
4 ай бұрын
Sir may transformer ako Ng peavey 2600,bkt Kya Wala ako m read n volts s secondary,lht Ng wire tinest ko Walang reading,pero pag hndi nkasaksak s 220volts meron nmn sya continuity?paano b I test ito sir?salamat
@jhondy21
Жыл бұрын
San po shop nyo pwede po ba mag pagawa ng peavey gps 2600
@jonasdelosreyes4421
5 ай бұрын
San po location nyo?? Pagawa ko sana pv2600 ko .wala tunog ung isang channel
@mharlonsunga8168
2 жыл бұрын
boss meron ako parehas nyan kaya crest cpx2600 nmn sya sira din ung channel B nya boss
@nikhpe
8 ай бұрын
eliminando quei 4 diodi ritorna a funzionare ? non ne a bisogno ? ( by eliminating those 4 diodes does it work again? don't you need it? ) italy
@antoniusriyanto1120
2 жыл бұрын
May I ask you, I have same pv2600, when i open volume full, there is any noise at channel B but channel A is clean, can you give me the clue what is the problem ?
@fidodidotech2789
2 жыл бұрын
you remove four signal diodes at the input of the buffer, it is connected from the signal input towards the supply for both + and - rails...... same thing happen with one of my repaired peavey amp...
@antoniusriyanto1120
2 жыл бұрын
I tried to dismantle input board, the noise disappeared, but when i connected nut of input lo/hi z, noise came up again, means - terminal cannot touch ground body, what wrong with this ? Any component fail ? Thanks for your respon
@fidodidotech2789
2 жыл бұрын
please do remove the signal diode that i mention it will iliminate the noise
@antoniusriyanto1120
2 жыл бұрын
@@fidodidotech2789 thank for your suggestion 👍
@antoniusriyanto1120
2 жыл бұрын
One more question, when i turn on the PA, sometimes it sounds jeduk, sometimes doesnt, what is the problem to this pv2600 ? It can damage speaker
Пікірлер: 17