Thanks so much! Couldn’t figure out how to get off the housing. Your video showed me about the two small Allen wrench screws. Tremendous help thanks a million!!!
@gerbrandceder755
9 жыл бұрын
Thanks ! Just replaced a motor in a Pentair pump and used these instructions. This was perfect.
@abstractplanet
9 жыл бұрын
Great video, exactly what I needed for my own diy.
@TheGeorge65
2 жыл бұрын
thank you so much!
@Dittohead73
8 жыл бұрын
thanks, i had the same problem with the bolts being f'n difficult.
@Rima-hh8db
5 жыл бұрын
Use wd40 or other penetrating oil
@ocmacman17
Жыл бұрын
You just ruined the diffuser by standing so much pressure on it. It will leak like crazy now.
@gmssails
3 жыл бұрын
Where is part two?
@FXSTC
10 жыл бұрын
Nice video, but where is part 2?
@libajane
4 жыл бұрын
I'm wondering the same thing. We've got it apart & cleaned up, now how do we put the new motor on? Bet it doesn't go on the way this one came off with updates, etc. Too bad you didn't finish the job! Will have to thumbs down for now.
@seoulbrooks
4 жыл бұрын
Why didn't you just change the bearings in the motor instead of replacing it? These motors are not cheap. The bearings (front/rear) are only about $10 - $12 for both. There are a couple videos demonstrating the bearing replacement. Good video as far as it went...
Пікірлер: 11