O think at the end the proper tool is not extrude, but offset. Your guide doesn’t look thicker but “taller”. Also it’s always nice to run inspector to see if there are errors in the meshes. But was a nice tutorial
@mujsketches5249
Жыл бұрын
how did you convert the DICOM file to STL file?
@odontologiaesteticaintegrada
3 жыл бұрын
que buen video dr. Como adquirimos el stl del tomografo?
@medsafouanejaada
4 жыл бұрын
what about undercuts ? this guide wont fit at all
@rodrigopino6626
3 жыл бұрын
Hola Dr. también tengo el sistema Sirona, esto se puede exporta con el mismo sidexis o es otro programa?
@drgarygutierrez
3 жыл бұрын
Hola Rodrigo ese es una tomografía que se convirtió a STL usando BSB.
@andaisofly
5 жыл бұрын
Hello, nice tutorial. But I have a question: will this fit the teeth easily? Won't it be too tight since the inner surface is the surface of the scan? Could we space them by 0.15 mm? Thank you
@drgarygutierrez
5 жыл бұрын
Yes, we need to space it a little bit.
@lorenasisca
3 жыл бұрын
@@drgarygutierrez how do we do that?
@rochacastillo240490
5 жыл бұрын
Hi, Which software you use to export the tomography to STL file?
@drgarygutierrez
5 жыл бұрын
alejandro rocha castillo uso el software de mi tomógrafo es un Sirona 3D.
@rochacastillo240490
5 жыл бұрын
Otra duda, de que manera "alineaste" ó "empataste" los 2 archivos en meshmixer, tengo el escaneo y la tomografía (ambos en .stl) pero no puedo hacer que queden como tu los tienes para trabajar con los 2 archivos en conjunto.
Пікірлер: 13