3 part series on making spin cast molds. In Part 1 you will be shown steps on what I have learned. Mold frame, silicone, master, layout, baking, hook holders and more. Part 2 is on kiss gates and gates. Part 3 is on burning in a mold and tuning it in (meaning if it needs vents). this is how I make my crappie, whitefish, and all other jigs for trout, walleye and pike. I use a 9 inch mold, there are 12 and 15 inch frames that are also use in spin casting tackle industry..
- Күн бұрын
Pete's Tackle Shop Spin Cast Mold Making Part 3 burn in and tune
- Рет қаралды 2,852
Пікірлер: 24