Not ever done one of these. Thank-you for sharing The ford and bmw is a common one. Done them before
@ORileysAutos
2 жыл бұрын
I couldn't find any other videos on this engine
@amirdjanmesropean5684
5 ай бұрын
35 Nm + 180 degree turn with angle gauge
@TheVabis480
10 ай бұрын
35 nm sitter den kvar ?
@TheMattn90
Ай бұрын
Hi I'm looking to do this on my 2008 1.6bluehdi allure. The parts store say that the belt may have two tensioner, is this the case?
@Mr330d
2 жыл бұрын
I’ve a very similar noise on 1.6 HDI however I already paid to have the timing belt done so don’t fancy paying the same again just to have this pulley done might try it myself 😂
@bartoszzbisawski7897
Жыл бұрын
How much you paid? 😂
@Adam2050
Жыл бұрын
So they do sound a bit chatty down low when not under load. Just had timing belt and gubbins too. Mine sounds like the end product before they get up to rpm
@DIYLONDON
7 ай бұрын
Hi jimmy, is it the same process for berlingo 2017 auto? Press the brake to stop crankshaft from turning? I was told it I take off crankshaft sensor there is a place to put pin in? Was a bit unsure. Thanks buddy, great work as usual , I wish you were in west london !
@grahamdunning294
2 жыл бұрын
Great job again Top man 👨
@ORileysAutos
2 жыл бұрын
Thank you Graham
@125sm3
2 жыл бұрын
Can't beat using a drill bit as a tensioner pin lol.
@ORileysAutos
2 жыл бұрын
Improvise. Adapt. Overcome.
@KjH-sq1sz
4 ай бұрын
Hi, what size is the tensioner bolt ?
@frankarmstrong9414
Жыл бұрын
Hi my woodworth key in the cranck has snapped while driven. Is this fixable or is it a new engine job
@hansjarlelnning7059
Жыл бұрын
The torque should be 35 nm + 190 degree
@papasmerf5705
6 ай бұрын
Exactly 👍
@leesmith8377
8 ай бұрын
No locking tools needed
@fernandostanic2035
2 жыл бұрын
My 508 1.6 ehdi have slight jerks when i lift off throtle. I changed everything, clutch flywhell, engine mounts, aux belt and tensioners. When i turn on A/c jerks are almost gone. Can it be related to bad crank pulley?
@lyriczboss
Жыл бұрын
No brother change the drive shafts mine made a metal noise when i left off the gas now when i changed those i put from 1.4 and the car felt so much better no jerking
@fernandostanic2035
Жыл бұрын
@@lyriczboss you also have 508 with 1.6hdi and robot gearbox?
@lyriczboss
Жыл бұрын
@@fernandostanic2035 no i have ford fiesta 1.6 tdci but that caused my jerking my driveshafts were worn and its a manual
@lyriczboss
Жыл бұрын
@@fernandostanic2035 its the same engine essentially
Пікірлер: 23