If you'd have dropped something down the exposed inlets, it would have taken a lot more than 26 minutes to get it out!Cover them up as soon as the manifold is off.
@Tyykiluoto
8 жыл бұрын
Yes, you should do that, but I had no time for it :)
@larppaxyz
9 жыл бұрын
Ensikertalaisella menee D8 mallin kanssa tulpanvaihtoon noin kolme tuntia. Viisi jos huomaa että takimmaiset tulpankolot ovat täynnä öljyä.
@juanjoserojas2074
3 жыл бұрын
Hello, men. I have a question. Could you tell me what is the ignition orde of the coils? I will thank you so much, or if you can share me an instructive or tell me where can i find them. Thank you.
@fastthruster
8 жыл бұрын
Fantastic. Could be easier with air filter casing off. Intake gasket renewed?
@Tyykiluoto
8 жыл бұрын
+fastthruster Thanks! Removing air filter casing doesn´t help, but removing the pipe between it and the throttle body would have helped. Between the upper (removed in video) and the lower part of the intake manifold there is a O-ring-type seal that can be used again, if the seal is in good condition. So no, the seal wasn´t replaced this time because I did it the last time the manifold was off :)
@fastthruster
8 жыл бұрын
+Tyykiluoto Engineering Yea. Mostly people doing in the same manner. Fortunately this engine not required dismantling intake manifold very offten.
@easyrider020
3 жыл бұрын
no need to disconnect the battery minus before?
@gerardoscarfone4760
Жыл бұрын
La admision lleva alguna junta?
@carlosbarragan1673
Жыл бұрын
Sip.. Luego ya no sellan bien despues de quitarla si no hay para cambiar. Se pone rtv silicon para juntas.. Y ya.
@gerardoscarfone4760
Жыл бұрын
Te hago otra consulta, el auto cuando enciende las rpm se van a 2000 . El circuito de paso a paso se puede anular?
@carlosbarragan1673
Жыл бұрын
@@gerardoscarfone4760 eso si te desconozco , puede ser algun vacio en alguna manguuerita de vacio rota.. o tu cuerpod e aceleracion esta mal.. a mi nunca me ha pasado eso..
Пікірлер: 13