Fantastic video , did both my rear pads and discs on my berlingo . Had to buy a 36mm socket. Had up too 34mm. Also had to learn how to use that wind back tool. Us pro special kit. Amazing. Need to do front now. Thanks for video.
@maxautouk
3 ай бұрын
Glad it helped
@chemistry636
Жыл бұрын
Not got a Peugeot. Excellent video as always. Well shot and explained.
@maxautouk
Жыл бұрын
Thanks very much for the comment 😁
@markwilliams2830
Жыл бұрын
This is an Excellent video tutorial Max.The camera quality is very clear.Thank you for your time and sharing.
@maxautouk
Жыл бұрын
And thank you for your continued support!
@jamesmiller2901
Жыл бұрын
Great video, very helpful thanks. Wish I'd seen this before starting on my Peugeot Partner.
@maxautouk
Жыл бұрын
Thanks for the comment, my older videos probably weren’t as good but I’ve been trying to be a little more clear so it’s nice to hear it was helpful 😁
@bunnygirl95
Жыл бұрын
Great video mate, my rears are pretty warped so gonna be replacing them soon. Finally found a decent guide :)
@maxautouk
Жыл бұрын
Thanks for the comment, I hope the job goes well!
@davidnewman5807
11 ай бұрын
Great vidro. Which way do you wind the calipers back?
@maxautouk
11 ай бұрын
I’m pretty sure they are right hand thread but i could be wrong it’s been a while
@dantheman7370
11 ай бұрын
Where did you put axle stand?
@maxautouk
11 ай бұрын
You can put it at the back where a tow bar would mound mount or if fitted you can put it under the tow bar itself but other than that you need to use the reinforced jacking points on the pinch weld You can often lift the front super high which lifts the back also and you can pop a stand under the rear jacking point Or you can modify your jack like I have to have a safety interlock 👍🏽 many modern cars are very tricky because they’re designed only to be safely lifted on a car lift - definitely don’t put a stand under the rear beam! It will bend it
Пікірлер: 14