Nothing better then a day in the shop. Drink-en, smoken, and brazen!
@williehall4755
3 ай бұрын
I have the hebejebes watching all the unnassary talk but it looks fair!
@wookieecantina
Жыл бұрын
Really well done, thank you for creating and sharing. This will be absolutely beneficial.
@papasfixitshop7982
Жыл бұрын
Thanks!
@chuckthebull
Жыл бұрын
Nice..i just welded up a broken hand wheel for my vertical mill and watched your video to get a feel for it (and others) thanks for taking the time to make it ..mine came out good as well.. ... I also enjoy a Corona from time to time. cheers!
@papasfixitshop7982
Жыл бұрын
Well done!
@tandemwings4733
4 ай бұрын
I can only pick you on one point. On such a small piece, I would not have ground so much parent metal out. The fill looked way too big, perhaps even twice too big.
@SystemsPlanet
2 жыл бұрын
I never knew this was possible. Thanks
@papasfixitshop7982
2 жыл бұрын
Yeah, this was a little piece. 30 years ago I cut my teeth on a broken locomotive transmission case. Epic.
@jllaine
2 жыл бұрын
This was wonderful, thank you so much for putting this together, it really shows a lot of details of the process. Glad that you detailed the 'torch flick' to keep the cast iron from melting, and how you were working the seam outside in, I learned a lot. Did I detect that you are also watching the 'texture' of the brass filler, keeping the working puddle no more runny than honey?
@papasfixitshop7982
2 жыл бұрын
Watching the puddle is key, when it cools slightly it looks wrinkly as it solidifies. Once heated again it turns fluid and very smooth. At that point is like as you say thick like honey but I heat it more and it will get thinner and lay down in the groove.
@edwheeler7507
5 ай бұрын
How can you braze with no goggles on?
@hu5116
Жыл бұрын
Hi Papa, enjoyed the vid! However, I don’t think you ever showed what you really did with that Silicon mold. Certainly, you did not stamp the metal with it. Nor flow brazing metal into it. So I really don’t know what you did with it. Maybe used it to surface some Bondo? I don’t think you ever say, or if you do, it was so fast I missed it. Otherwise, nice repair job and thanks for sharing.
@paulwilliams9036
Жыл бұрын
Who taught you to braze
@papasfixitshop7982
Жыл бұрын
As an 18 year old apprentice in Auto Body I learned from my Master back in the 1970’s at a Cadillac Body Shop. Thanks for the question.
@johnhironimus5748
Жыл бұрын
You are not good at this y decive people
@papasfixitshop7982
Жыл бұрын
Please explain your position, I’ve been doing this type of repair for over 40 years without a single complaint or failure.
Пікірлер: 18