The information shared in this video was very useful.And it is our humble request that the information you share will be more useful in future if it is mostly unknown information related to piping. thanks for your outstanding KZitem channels.
@sen-ow7ub
Жыл бұрын
It's great that your videos are coming regularly now. Please can make topic about non rated flange or plates are using for some of isolation purposes. In addition line during maintenance if required any nitrogen preservation. Please explain about this topic.
@aghilmoghbeli7626
Жыл бұрын
Thank you very much for your good videos
@sen-ow7ub
Жыл бұрын
please post the video about Blowdown Valves with a practical explanation. awaiting for your reply. thanks sir
@MrSinghtejpal
Жыл бұрын
👍
@thespj9684
Жыл бұрын
Very useful.Where can I get the chart you used in your calculation?
@gourisankarsamanta7670
Жыл бұрын
This type of chart is available in piping handbook and in vendor's catalogue.
@AHMEDALI-rq7jg
Жыл бұрын
Please Can you share the chart of opening Space?
@gourisankarsamanta7670
Жыл бұрын
This chart is already there in the video.
@AHMEDALI-rq7jg
Жыл бұрын
@@gourisankarsamanta7670 I mean a PDF file, or wich standard
@thespj9684
Жыл бұрын
Any of it would be appreciated
@saidiramzi2470
Жыл бұрын
How to specify the required mesh for a specific process
@gourisankarsamanta7670
Жыл бұрын
It depends on precess requirement and machine vendor's requirement.
@saidiramzi2470
Жыл бұрын
I have a conical strainer for condensate process with 4"(i can share with you the data sheet and vendor drawing). Now i need new one with 2" for same process just (flow rate it is 1/2 the existing one) could you please advise how i can size the length and required mesh?
@gourisankarsamanta7670
Жыл бұрын
@@saidiramzi2470 required mesh depends on process requirement and filtration requirement of downstream eqpt. Please calculate area of conical perforated sheet. Available open area shall be about 25% of this area. This available open area should be minimum 2 times of pipe cross sectional area. In this way you can select conical strainer dimensions.
@saidiramzi2470
Жыл бұрын
Do you have any standard or chart that specify this requirement of available open area should be at minimum 2 times pipe cross section.
Пікірлер: 17