I kicked an exhaust rocker following your instructions to the T . Set it at 5 and no problems yet
@markstreet7431
2 жыл бұрын
Thank you sir. I wasn’t sure about which ring went where. Luckily i got that exact type piston. From u. Thx again
@shaunthompson1935
Жыл бұрын
I ordered a short block gx200 clone and the piston was already installed and the arrow on the piston was pointing up . That's how it was delivered to me
@TheGrayGoatGarage
Жыл бұрын
I would correct that before running the engine. The pins are offset and the triangle or dot must face the pushrod area
@ol-man-duffyj688
9 ай бұрын
GG strikes again with the BOOK OF KNOWLEDGE 🙏🏻 🤲 Thank you
@AllGreatTruths
2 жыл бұрын
I have a 196 clone and I'm removing the connecting rod and piston to throw some new rings on with a fresh hone. Can i safely reinstall the rod onto the crank,torque it down and go?
@markday2198
Жыл бұрын
My black ring ( center ring ) doesn't flex at all once installed on piston . Can't depress to install piston into cylinder .
@NFSINSANE
2 ай бұрын
Great video, exactly what I was looking for!
@ulyssescontreras4360
3 жыл бұрын
What size do you need for a non hemi rod and piston
@Partnerthedog
2 жыл бұрын
What do you mean, you didnt say what engine. Gx200 196 clone or 212 predator. Then you go on the website and shop for your engine. It tells you what parts fit
@thesw313tspot8
2 жыл бұрын
my motor has a 65mm piston. what rings would i need
@joshuaboey366
2 ай бұрын
Do you need to offset the rings 180 degrees out???
@joshuaboey366
2 ай бұрын
Each rings slot I mean
@TheGrayGoatGarage
2 ай бұрын
@@joshuaboey366 Yes, I set my ring gaps 180 degrees apart. and have the end gaps by the pin. This is something that has been debated for years about what is the proper way. This may not be what everyone does, but it works for me.
@ulyssescontreras4360
3 жыл бұрын
What’s size is your flathead and rod
@dejonjennings3767
2 жыл бұрын
what size gap do you need for it?
@SHADOWO05
2 жыл бұрын
No need to oil/lubricant the rings?
@Rabbit.760
4 ай бұрын
I would
@stanleyshults6427
Жыл бұрын
What about clearance on wrist pin,u never said about it,,or piston bosses,,rings could , B ALTERED IN DIFFERENT LOCATION ALSO,,HELLO WAKE UP FOLKS!!!!
@TheGrayGoatGarage
Жыл бұрын
Please do your own video that shows what you are talking about and link it here. We could all learn from you! Share the knowledge!
@aleidabianchi1434
Жыл бұрын
I did it myself with the Woodglut plans. I think this is the best way to find out how to build it.
Пікірлер: 21