Great video I didn’t think you could rebuild the pit bikes and sold mine when the compression went low now I see i made a mistake selling it saving for a mx bike tho
@handsomefingers7759
3 жыл бұрын
yeah and it is much cheaper choice than mx bike.
@Rectro-V2
2 жыл бұрын
Done this but when spinning the flywheel enough it comes to a complete stop won’t budge but turn it the other way goes for abit then won’t budge again?
@kursutin2446
3 жыл бұрын
That bike is not running correctly, the rpms are floating. And are you sure there isnt any metal parts that flew to to the cases when the bike blew up? Might cause some damage in the future.
@handsomefingers7759
3 жыл бұрын
there was air leak in rubber intake manifold and it made rpms float. and yes i am sure that there isnt any metal parts ir crankcase.
@kursutin2446
3 жыл бұрын
@@handsomefingers7759 Ok nice :)
@watai
3 жыл бұрын
do you remember the 2 bolts inside the head you forgot to put it back on ? I lost them, do you know how long they are? Thanks !
@yorkshireriding3260
3 жыл бұрын
How did u do the timing chain and know when it’s perfect just ordered new head for my yx160 and have no clue about the timing
@handsomefingers7759
3 жыл бұрын
turn magneto that T mark is aligned with notch in case, cam sprocket turn that lines align with notch in head.
@handsomefingers7759
3 жыл бұрын
and then put on chain
@yorkshireriding3260
3 жыл бұрын
@@handsomefingers7759 oh thankyou I’ll take a screenshot off that and let you know on day when it’s done aha
@somtingwongwai7194
3 жыл бұрын
@@yorkshireriding3260 This guy explains step by step how to do that in the video link below. should be Same principal as mention above kzitem.info/news/bejne/xXqeraKOs2eqfn4&lc=UgxYdWmnW-mJ1a9xrhx4AaABAg.9OXC1LK6nbH9O_HH8qb3sI
@brotherkhan2885
3 жыл бұрын
Hello, i have a 160 but the carb hits the tensioner, were do you get that intake rubber boot from and how do you fit?
@handsomefingers7759
3 жыл бұрын
hi, you can get it from ebay or aliexpress. Rubber boot mounts on intake with screws, but depending on intake you can use silicon hose in necessary diameter.
@brotherkhan2885
3 жыл бұрын
@@handsomefingers7759 do u have facebook
@raymondharlen2753
7 ай бұрын
Can I have the old head?
@dylanbelley1761
2 жыл бұрын
Did you hone the cylinder or anything?
@handsomefingers7759
2 жыл бұрын
nop, cylinder didnt haave any damage
@gala83filmstaylorg7
2 жыл бұрын
Not one bolt tighten to spec lol
@handsomefingers7759
2 жыл бұрын
And engine still runs.
@gala83filmstaylorg7
2 жыл бұрын
@@handsomefingers7759 surprising
@eleazarmejia
3 жыл бұрын
mofleta para súper cub kzitem.info/news/bejne/pGyY1ZuBhXh-dHY
Пікірлер: 24