putting the strips on the inside of the mold and the surface will be smooth
@badkid5690
7 жыл бұрын
I loved doing that project :)
@mariae6942
6 жыл бұрын
Well done video!! Thank you for sharing this!!
@jenellnovello1619
11 ай бұрын
Curious, when you plaster an actual face, it pops right off and can cure overnight. Why must it dry overnight on the mold, or can it also pop off and cure overnight?
@tiagarcia5903
5 жыл бұрын
hello, i thank you for your mask demo.Would you do a stencil of and African American child and adult please?????
@Mama-bear184
3 жыл бұрын
Samantha can you do the straps on styrofoam face molds?
@olswole3658
3 жыл бұрын
Greetings, would it be possible to pour the inside of the mask with plaster in order to form a thick blank for vacuum forming?
@mr.classicragememerook96
Жыл бұрын
Do I need saran wrap for the face form or should I leave it without the wrap?
@shanlon11
6 жыл бұрын
Any way to speed up the process? Can you paint the mask prior to removing the plastic mold?
@SamanthaWoodArt
6 жыл бұрын
+sharon hanlon you could try drying it with a hair dryer...I️ wouldn’t recommend painting it while on the mold because then the moisture would be trapped between the paint and plastic mold and might not be able to dry properly. Another thought... you could try removing the mask from the mold after a few hours, once it’s strong enough to retain its shape, and then it would dry faster because it would be able to “breathe” on both sides...hope that helps!
@shanlon11
6 жыл бұрын
Thank you! I will let you know how it goes :-)
@Mama-bear184
3 жыл бұрын
Well how did it go?
@theallpaperthings7438
6 жыл бұрын
#Theallpaperthings😍😍😘😘
@jrnck
6 жыл бұрын
Is there any way to polish the plaster after making the mask, and is it alright to cut holes in the mask after forming it?
@SamanthaWoodArt
6 жыл бұрын
You can sand it lightly with a fine grit sand paper before applying paint and a clear coat. And I have drilled small holes in mine before, so that I could run wire across the back to hang it from. It worked best when I drilled the holes after painting and clear coating it, since the plaster was stronger when coated. Hope that helps!
Пікірлер: 18