@THE MACHINIST. Good demonstration of the Clamp Optimisation Function! My experience of Polar cutters started in 1977 with the generation "CE" (contactless Eltrotact). On that generation, during a programme, when the clamp returned to its highest position then the backgauge would move to the next position on the cut sequence. This was triggered by a microswitch "b29". Later - and on your cutter, that switch became "s29" which probably means that it was a non - contact sensor. So maybe the clamp optimisation function relies on the s29 having a variable sensor range. This means that you can set up coarse, medium and fine setting for the height that the clamp "floats" over the pile of paper. So an uneven/wavy pile of paper would need the coarse setting. The clamp optimisation is set as an extra function to start with a specific size for a forward run of step and repeat cuts. After the final cut on the pile, the clamp optimisation cancels so the clamp lifts up completely for a new pile or to turn strips etc. This function speeds up the clamp and cut cycle, so each load of the machine is finished quicker. Keep up your good work!Stay safe and well.
@marconiparello
3 жыл бұрын
You have good technical knowledge. I rarely use this function, some repetitive label jobs, which saves me time. I've seen a polar CE up close, not operating this machine but I noticed similar signals on the control panel. Thanks for watching my video.
@MrQuirinus
3 жыл бұрын
🔝👍🏻
@rosaliafirmino1316
2 жыл бұрын
😍
@echegrizouhair3462
2 жыл бұрын
Hi a want to how to change the lame
@marconiparello
2 жыл бұрын
kzitem.info/news/bejne/1KSQummCbpuDi6Q
@marconiparello
2 жыл бұрын
If you operate a polar machine.
@marconiparello
2 жыл бұрын
But be aware that there are two types of knife clamping system.
@echegrizouhair3462
2 жыл бұрын
Yes I'M but I'have difficult
@echegrizouhair3462
2 жыл бұрын
To change if you can to show me how
@marcelinocastillo8558
Жыл бұрын
Como puedo conseguir un manual de operación
@marconiparello
Жыл бұрын
¡Hola! Hablo portugués pero entiendo muy bien el español. Descargué el manual por Internet gratis en español.
@marcelinocastillo8558
Жыл бұрын
@@marconiparello muchas Gracias.
@marconiparello
Жыл бұрын
@@marcelinocastillo8558 ¿¡Dudas!? Puede contar conmigo.
Пікірлер: 17