So my dad in the military works with the rescue squadron for the airforce. They have 4 seat 2013 MRZRs (rzrs for military) and he is bringin me a motor from one that they crashed and im gonna tinker with it. This video is gonna help me out. Thx
@viper7016
3 жыл бұрын
You guys are just AWESOME!!! Thank you!
@rmatvmc
3 жыл бұрын
Our pleasure!
@PitPwny
5 ай бұрын
All because I stripped the oil pan…thanks for the instructions.
@cameronsaint116
3 жыл бұрын
I have to rebuild mine at 40 hours “dirt in the engine” says the mechanic. The dam thing was almost neeeeewwwwwww
@rmatvmc
3 жыл бұрын
What a bummer! It's really not that bad to do, it's just time consuming. My only advice would be to turn on some music and enjoy the process. -Charles
@jaimesbrewer3015
3 жыл бұрын
Great video
@breakitfixit5102
Жыл бұрын
The rear springs, I see the primary are fully collapsed, is that normal? I ask as I bought mine use that way and don’t know if they are worn completely.
@nsarboc
3 жыл бұрын
How many miles were on it?
@jacobecavalier1499
2 жыл бұрын
Hi I have a high idle as long as I have my tps bolted to the throttle body as soon as I pull it away so the vacuum won’t reach it I can adjust idle manually with the screw can u tell me what’s wrong
@kylekocurek9007
3 жыл бұрын
Would the 900 xp ranger be the same steps as this project?
@jeffnelson573
2 жыл бұрын
Hi Jeff here, what can I do as I have just replaced the value cover gasket on my 2016 polaris ranger Xp 900 and it still leaks oil a little bit yet as you can still smell it when you stop riding.I cleaned up the cover and the head before I put the rubber gasket on, so what can I do to fix this problem??? I also replaced the cover bolts and the little rubber washers so I am stumped as to what to do next, Thanks for your time,
@rmatvmc
2 жыл бұрын
Hi Jeff, I would try to find the exact spot it's leaking from. That's usually the wettest area, but if you aren't sure, clean it off and spray some foot spray powder on there, then run the machine. That should clearly show where the leak is coming from. Is the cover cracked or is the sealing surface damaged anywhere? Sometimes the corners of the half moons don't make a good seal, so you can use a dab of silicone sealant in the corners. -Charles
@rmatvmc
2 жыл бұрын
...also check the oil cap.
@RichardWells-ft6sf
11 ай бұрын
Great information, and quality work being done. Wondering about availability of aftermarket parts to rebuild the 99 sportsman 335?? The most I see on Amazon is the oil pump....
@user-bz1nj7pz5r
8 ай бұрын
First mistake is looking for engine parts on Amazon
@chrismathews4478
3 жыл бұрын
Do I have to remove the transmission from the engine if I intend to pull them both out to place in another SXS?
@berniemac8413
Жыл бұрын
Did you ever find out the answer?
@seant6624
3 жыл бұрын
When are you guys doing the 1000 engine removal and rebuild?
@rmatvmc
3 жыл бұрын
Soon! Should be within the next week or 2.
@wadesale2958
3 жыл бұрын
how much time to remove engine from start to finnish
Пікірлер: 23