Great simple project, I was sure you had used a router to make those ovals but I really liked your OSHA approved method
@nwbuilds
3 жыл бұрын
Funny you mention that. I tried making a template and then using a router with a bearing to copy it, but it turned out so poorly that I did it this way instead lol
@brentlazzarino7171
3 жыл бұрын
Sweeeet
@nwbuilds
3 жыл бұрын
Thanks brent!
@noahy7305
3 жыл бұрын
Hey I was wondering what kind of clamp your using at 2:05? Thanks
@nwbuilds
3 жыл бұрын
Hello Noah, they're these corner buddy clamps. A few different manufacturers make them I think, all of comparable quality: amzn.to/3hTLg4W They don't really provide any holding pressure, but act as an extra set of hands. I'd buy them again.
Пікірлер: 8