Todd from Project Farm voice: very impressive performance from the 357xp!
@kingsaws
3 ай бұрын
Those two saws harmonized together very well!
@kraftzion
3 ай бұрын
Well I ported my first 2 saws. A 4218 strato that started with a 14 second cut stock. I got it down to 9 seconds with mods not including porting. Went from 9 to 7 with porting just widening and raising the exhaust, lowering the intake. The second one was a 4620 poulan that I had already optimized everything outside the motor and did a 6 second cut. With porting it went down to 5 seconds. I blew right through my intended number on the 46. Trying to port with a 1/4" air die grinder . Went from a 108.5 exhaust roof to 97.5. Fully expected it to fall on its face. Amazingly it didn't.
@crazyfeller5704
3 ай бұрын
👍👍
@georgesjunk
3 ай бұрын
Dont beat too hard on mac. A mac 850 and Husqvarna 281 are equal speed and power If you're taking about the mcbricks or cinderblock macs then yeah.
@tatepazaski5488
3 ай бұрын
Great versus video. Those are my favorite. This was an interesting ported versus modded upper cc battle. I could see you may get some backlash for the end of your video but it's true, just because you love your old saw Betsy doesn't make it faster in a one-on-one.
@aaronpowell4885
3 ай бұрын
👍🏻 just because I like my little old Poulan 2000, would it hold a candle to an ms250? Hail no! Would it even beat a stock ms170🤔😅
@Doc-Cole_Trickle-of-Chainsaws
3 ай бұрын
@@aaronpowell4885 😁
@redtiller1975
3 ай бұрын
I was impressed by the 357. Once it is broken in it might beat the 565
@robbevington1754
3 ай бұрын
I would do the VS the 372 that’s one a lot of people would understand or relate with
@rise_above
3 ай бұрын
Did you ever compare the 359 ported to your 357 ported?
@Doc-Cole_Trickle-of-Chainsaws
3 ай бұрын
👍🆙BigGuy
@aaronpowell4885
3 ай бұрын
Good stuff👍🏻
@Houseworksaws
3 ай бұрын
Actually didn’t do too bad. Figured the 565 would just runaway with it. The ole 357 held its own.
@novicelumberjack
3 ай бұрын
I can't help myself... I'm going back in! Same stuff I did to the Makita, this 357 is gonna get it!
@novicelumberjack
3 ай бұрын
I figured the same thing. With the muffler mod, I'm pretty sure the 565 will beat a 572xp.
@Houseworksaws
3 ай бұрын
@@novicelumberjack Excited to see what you can get out of it.
Пікірлер: 17