great to see you working on you own stuff ... great vid
@janousekmike
25 күн бұрын
Long overdue, definitely need to make a point of it.
@miguemazda8627
27 күн бұрын
Nítido 👌🔥
@janousekmike
26 күн бұрын
Gracias 🙏
@billynomates920
21 күн бұрын
2:00 two rotors, two hammers, got it! 😁
@janousekmike
21 күн бұрын
Lmao 🤣 good call, I was actually using the hammers earlier on a wear ring install for my jetski, nice catch lol 😂
@billynomates920
21 күн бұрын
@@janousekmike it was just the way they were leaning together that tickled me! it must have been a good minute before i'd noticed! 😄
@andygray563
20 күн бұрын
I'm surprised you just did the large face port freehand, with no outline or guide marks? Wouldn't that create the chance of small variances between each port?
@janousekmike
20 күн бұрын
If someone has never ported a rotary or used a dermal before, I would absolutely recommend porting templates. Over the years of porting rotary engines I now use the engine casting, wear pattern, seal positions and feel which has worked great for me.
@gerhardengelbrecht9679
2 күн бұрын
Top side of the port is wrong!! Its gonna eat into the plate needs to be straight dude
@janousekmike
Күн бұрын
Interesting, I’ve never had that problem. I’ve seen side seal wear chop on irons before. Normally happens when people run the cutting edge of porting towards the water jacket, and the upper left corner of the ports also side seal will show extensive wear.
Пікірлер: 14