I've had a heck of a time finding any videos about the vacuum features of the BVM200FE. It was good to see this short section here at least.
@davekana8388
4 жыл бұрын
Someone just gave me a nonrunner. Got it going, used 40:1 mix. Is that correct?
@arlenearme703
11 жыл бұрын
glad you got the video instruction especially with the assembly for the blower. i used the oil mix i bougjht at lowes when i bought this blower.
@zackk695
8 жыл бұрын
I have the same blower that is a year old.Carb will not prime at all.Does anyone know where the air pulls from? I changed carb last year and it rain for a year until it starting bogging bad.I took carb off and cleaned it and blew it out but still cant get a prime which is going to be the problem.Fuel lines and returns are clean.Where on the carb does the primer pull air from? Thanks
@devinchristian9237
10 жыл бұрын
Good luck getting any customer service!! They will not stand behind their warranty. You will end up on a never ending circle of automated prompts and try to call the operator and it will send you back through the same loop over and over again. Buy at your own risk!!
@animalcorvair
10 жыл бұрын
these are easy to fix but got lots of these i am seeing with stuck rings then they wont start mine is a craftsman.. same thing .. it was given to me ..i own all poulan saws never had ring problems need to run 93 in them ???
@jacobditmer5579
7 жыл бұрын
I already bought a Stihl
@irregularmana6216
5 жыл бұрын
Tried doing this 8 times already....
@deej77066
5 жыл бұрын
irregular mana You probably flooded the engine ( Poulan ProBlower). Press and hold the trigger then place the lever on RUN. I use Trufuel which I purchased at Home Depot ( $5.94 40:1). I cleaned the filter and FINALLY it started!!
Пікірлер: 12