Pretty straight forward process, but just to confirm. At the beginning you installed 2 power injection points to the actual controller. But in this install you are only using one power injection line? If you would need to use the second power injection line how would you go about doing that, lets say the house is 180 ft, or whatever ft is required to start using your 2nd PI line, would you still run that line threw the track, or would you cut across the entire house attic?
@showhomelighting5840
8 ай бұрын
I don't show it in the video because I did it later, but I went around the other direction from the controller and did the same thing I did in the video injecting power up to 80ft from the controller with that second power injection line. The two runs met at the corner where I stopped in the video.
@papabrose
7 ай бұрын
Where did you get those pucks that have a connector between each puck?
@billfoster6809
9 ай бұрын
So you’re putting 2 Y-splitters at the spot where the next 5 LEDs will connect? Maybe you can make a short, close-up detail video of that.
@showhomelighting5840
8 ай бұрын
Yes, I think this video needs to be redone and more to the point. Something for me to work on. Thanks.
@honrado80
4 ай бұрын
May I know what type of cable you use for power injection
@showhomelighting5840
2 ай бұрын
We just get custom ones made for us, they are a 16awg 2 wire with a dc barrel connector on the end.
@honrado80
2 ай бұрын
@@showhomelighting5840 is it copper wire or just a normal wire.
@davidfleck1654
9 ай бұрын
are you running one DC injection wire with multiple drops along the way. Parrell wiring
@showhomelighting5840
9 ай бұрын
Yes we are running a separate DC only wire from the controller inside the track and Inject power at 40ft and 80ft in both directions.
@davidfleck1654
9 ай бұрын
so its one DC wireand then two drops from that single wire correct.@@showhomelighting5840
@hasanh.8262
Ай бұрын
@@showhomelighting5840 are you using the same dc line to inject twice or 4 times
@doncoleman5090
11 ай бұрын
Where can I purchase the input power box and controller? I need to inject power to a tree with LeD lights. There flickering now. I just need to make sure that I’m getting 12v at each section
@showhomelighting5840
11 ай бұрын
What are you using for a power supply to run the lights right now? Can you just run more power from that power supply to feed power to multiple locations.
@fin3125
10 ай бұрын
You should post links where to buy the items. You can make a few dollars and we can find what we're looking for.
@mrv8rick2
9 ай бұрын
At the website Showhome lighting
@Dc-bi4ov
10 ай бұрын
Super confusing
@showhomelighting5840
10 ай бұрын
Sorry, I'll try to make it easier next time. Which part is hard to understand?
Пікірлер: 18