This is how to make a powerful thermoelectric cooler box. It was able to reach -7°C in just 10 minutes. This is great results as I was only able to reach 0°C in my previous attempt. I love peltier projects, I find them very interesting and if you would like to join me, go ahead and pick up the necessary components here:
BIG heatsink: goo.gl/gFi6e4
200W peltier: goo.gl/424CNx
Fan: goo.gl/jKJ3tR
Small heatsink: goo.gl/95fw6L
Temperature controller: goo.gl/DwLWtJ
Hinge STL: goo.gl/jYk6nP
The setup is highly inefficient running at 10A. You could save a signifcant amount of power by going nuts with the insulation and therefore take advantage of the temperature controller and use it to turn the peltier on or off at a set temperature. I was using thick 30mm foam, but in order to avoid too big of a mess I later changed to 6mm depron foam. It might not be as good of a insulator, but it is more stiff which might be valuable.
My Favourite 3D Printer:
Creality CR-10 Golden: goo.gl/L2UayK
Creality CR-10 Blue: goo.gl/xMBWCj
Follow Simon Sörensen:
Facebook: / rclifeon
Instagram: / rclifeon
Watch More RCLifeOn:
More 3D printing: goo.gl/Qp7I5V
DIY projects: goo.gl/lJLOjH
3D-printer reviews: goo.gl/S2hCGi
Everything radio controlled: goo.gl/F7I5b8
Негізгі бет Powerful Cooler Box - DIY Peltier Freezer
No video
Пікірлер: 919