Brother PR600 / PR600II / PR620 6 needles embroidery machine hoop sensor calibration.
Update: Newer video with sound and caption link.
• Brother PR600/PR600II/...
Steps:
1. Hold these two buttons and turn on the power at the same time
Goes to AD test mode page
按住這兩顆按鈕並同時打開電源, 讓刺繡機進入到AD 測試模式
2. Keep holding until you see the calibration page on the screen
一直按住這兩顆按鈕不放, 直到屏幕上出現校正設定頁面
3. Attaching the left side of the Frame holder arm to the position 4
將繡花框支撐架寬度調整到第4格位置(S Save)
Position 4 is for mount the 60mm x 40mm hoop on the frame holder arm
這個位置是 60mm x 40mm 正確安裝進繡花框支架的位置
4. Tightening the 2 thumb screws certainty
將繡花框支撐架的2顆固定旋鈕確實轉緊
5. Press the S Save to correct its value
在螢幕上按下S Save 校正電壓值成新的機器測到的數值
6. LL save is using to correct 300mm x 200mm hoop in position 1
LL Save是校正300mm x 200mm繡花框正確安裝進繡花框支架的位置
7. Attaching the left side of the Frame holder arm to the position 1
將繡花框支撐架寬度調整到第1格位置 (LL Save)
8. Tightening the 2 thumb screws certainty
將繡花框支撐架的2顆固定旋鈕確實轉緊
9. Press the LL Save to correct its value
在螢幕上按下 LL Save 校正電壓值成新的機器測到的數值
10. Press the CLOSE icon to finish calibration then turn off the power
按一下螢幕上的 "關閉"來完成校正步驟然後關閉電源開關
Негізгі бет PR600 / PR600II / PR620 hoop sensor calibration
Пікірлер: 25