I recently installed this exhaust in my '07 120 series, I found it easier for that back bolt on the turbo to use a 3/8" or slim profile 1/2" uni adaptor and extension bars and come up along the inside of the cat. To get the tail piece in, I had to remove the fuel tank protector plate and the fuel tank strap to clear it, though I don't have that rubbing issue. And the transmission mount lined up perfectly, no mod needed there. Nice video
@mdags1978
5 жыл бұрын
That's interesting...maybe there is a slight difference (vs 150) in the bend near the rear axle.
@johngobel2635
3 жыл бұрын
I also have 120 (2009) however mine is also scrubbing on rear axle which is irritating, did you end up adjusting the hangers?
@crazyethanyeahyeah
5 ай бұрын
thanks for the video ... did you have to replace the turbo to turbo back gasket?
@remyche8768
3 жыл бұрын
Wd40 or inox is my favourite bolt's the day before works great
@ronaldkingi2119
5 жыл бұрын
Nice vid, can we get a video of what it sounds like? I’d like to hear it . Cheers!
@mdags1978
5 жыл бұрын
Hi Ronald - sorry about the delayed response - i didnt realise i received messages/questions (i'm a novice KZitemr). In short, the sound is hard to capture on the phone/cam. To be honest, its very subtle in relation to the difference.....definitely a little deeper under-load but still very quiet....i use my car a lot for family touring and wanted it close to stock. I believe there is a muffler delete option if you want it louder but not sure if you want a 3L diesel grumbling! :P
@misterpotato4775
3 жыл бұрын
@@mdags1978 can you just record it please mate?. I don't mind about it. As long as I could hear it. Because I'm not pro in terms of imagining how it sounds like
@johnclark5182
5 жыл бұрын
Thanks for the video, any improvements? And what does it sound like? Follow up video!
@mdags1978
5 жыл бұрын
Sorry for the delayed response John - see my reply to Ronald above.
@stevesanders3992
5 жыл бұрын
I have the same prado, does this model put some of the exhaust gases and back into the inlet manifold?
@mdags1978
5 жыл бұрын
Hi Steve - i don't believe so....that is, its essentially a direct OEM replacement - same bolt layouts, etc.
@stevesanders3992
5 жыл бұрын
@@mdags1978 great thanks.
@felixthecat1672
5 жыл бұрын
How does it sound? Much improvement in performance?
@mdags1978
5 жыл бұрын
Sorry about the delayed response - RE: Sound (See response above for Ronald). RE: Performance - to be honest, i can't tell any real difference.....fuel consumption hasn't changed....i could argue that it 'feels' better under-load when towing up to about 3K RPM but i'd be clutching at straws to quantify anything. Basically, i wouldn't buy it for performance improvement (i had a hole in mine original, hence, the reason why i changed it).
@elliotyoung6033
5 жыл бұрын
what brand of exhaust is this, cheers
@sameeragayan9092
5 жыл бұрын
Nice vid, thanks for that , will you be able to post a clip with how it sounds now, thanks :)
@mdags1978
5 жыл бұрын
Sorry for the delayed response Sameera - see my reply to Ronald above.
@unclebob5686
5 жыл бұрын
Good video, but in all honesty, what do you expect from 4wd Supacentre? Cheap Chinese exhaust that doesn't fit correctly. That rubber insulator you've used will pretty quickly rub through and cause a vibration.
@CatiePotatie27
5 жыл бұрын
They aren't Chinese, they are made here in Australia by Berkley. I hav one of the earlier stainless pipes from them for my Prado 150 but the dump pipe cracked and Berkley replaced it no problem with the modified version with the mount going to the bell housing which stops a lot of wobble on idle in drive. I'm sure it will stop the cracking. Other than that quality looks and fitted as good as any other brand out there and the sound has a nice note to it not loud at all. Power was a slight improvement towing but then I had the car remapped and now it really gets going and pulls like a train.
@unclebob5686
5 жыл бұрын
I stand corrected, they are made in Australia. Pity the quality is crap.
@CatiePotatie27
5 жыл бұрын
@@unclebob5686 I don't no if you have had a good look at them but over the years I have many of the name brands and custom pipes done and they compare very well to those.
Пікірлер: 22