Cheers mate, I took both bolts out and used the washers as they were and it worked a treat
@smeetos
2 жыл бұрын
You're a legend mate. Thanks so much for taking the time to make this video. It worked an absolute treat.
@richhayrobrokke6171
2 жыл бұрын
Can you give the size of the washers mate?
@erty1100
2 жыл бұрын
M12 washers
@uugankhuun8575
2 жыл бұрын
Does this run for other doors?
@YomAlwa3eed
2 жыл бұрын
Why did u cut them? why didn't u remove the bolts and used the whole washer?
@An_Idiot_in_the_Wild
11 ай бұрын
Because it's pretty tricky for one person to get the washers in. Even after you loosen the bolts the weight of door keeps the gap closed there where you want to slip the washer in. So if you don't have someone to help you by lifting and maneuvering door, in order to create a gap for you to slide washer in, its difficult. If you so get the washer in, it can be very tight and you have to get the hole lined up just right or then you cannot put the bolts back in! So its safer to cut a wedge out of the washer, and tap that in so the washer goes round the bolt, without removing the bolt. I actually did take the bolts right out, and i managed to do it myself but it was a bastard. I had to take spare wheel off the door and get a jack on top of 2 milk crates in order to lift the door a little to create space for washer. Even then it was almost impossible. So unless you have a friend to help, it is advisable to cut chunk out of washer. You don't need to cut such a wide bit out though. Just need enough that you can get the bolt through the gap without too much ballache.
Пікірлер: 7