It would be helpful if you explained what you are doing.
@helmkampchris
2 жыл бұрын
Thans for the video , very nice! Could you please give some more info on the setup when neckturning, what type of electro motor is that and what about the quick close collet for the brass ? Thanks ;-)
@steyrman2
4 ай бұрын
Hi what is the stage you are doing with the brass at 4-10 cheers
@Popojub
3 ай бұрын
lapua scales have different neck and shoulder thicknesses. When you convert 6BR shells to 30BR, you replace part of the shell shoulders with the neck. Then a donats is formed, I remove it with a reamer.
@steyrman2
3 ай бұрын
@@Popojub thank you for the reply keep up the good work sir
@br4713
2 жыл бұрын
Hi Piotr, how many expander passes does it need from 6mm to 308 ?
@Popojub
2 жыл бұрын
three expanders with a diameter of 6.70mm, 7.17mm, 7.82mm. You have to remember that the expander in the turning device must always be 0.02-0.03 mm smaller than the expander which is pushed. 7.82mm and for turning 7.80-7.79mm
@Popojub
2 жыл бұрын
For example, Papkin and K&M have a .308 "turning a .307" diameter while others, such as Sinclar, 21st, PMC have a .307 "turning a .306" diameter. There is always this dimensional relationship.
@br4713
2 жыл бұрын
@@Popojub Thank you, this is the perfect cartridge for shooting at 300m. I dont know why we dont see it so much in the shooting ranges, maybe not enough choice for match bullets with such light weight ?
@bossebatong
2 жыл бұрын
Hi Piotr. What type of drill is that?
@Popojub
2 жыл бұрын
It's not a drill, it's a reamer. I have different diameter reamers. So far, I used the 7.7mm reamer as the first, the second has a diameter of 7.8mm. See if it's enough, I have other reamers 7.82 7.84 7.86
Пікірлер: 11