How to prepare vacuum bagging materials for a wet-layup or pre-preg composites job. It'll be boring but you might learn some tricks if you're new to this.
Key ideas:
1 - Spray-glue the breather to the perforated release film.
2 - Cut peel ply on the bias (+/-45 to the fiber) so it conforms better if you need strips to go around corners.
2 - Put the sealant tape on the bag - even a big one.
3 - Kit all the pieces of bag stack material before you mix resin. Be prepared - and organized.
Learn more about vacuum bagging here:
explorecomposi...
Негізгі бет Preparing Peel-ply, Release Film and Breather for Vacuum Bagging
Пікірлер