/ @sajalazlanesh
Pro Tips: Resoldering Nissan #Throttle Body Mass Airflow Sensor
this video brings you full detail on Resoldering of throttle body of Nissan Micra K11 z10 CG13 CGA3 engines Mass Air Flow Sensor.
when your engine start hesitations or rough idle or if you press the brake padel and engine RPM suddenly dropped or engine off it means your MAF sensor has dry solder connection. in the order to repair it you will solder it again to fix it. you will have to open the mass air flow sensor cover and only apply paste to soldering points and apply hot solder iron to refresh the connections. then cover up the sensor with top plate and apply silicone to is edges.
#nissan #Micra #k11 #sparkplugs #distributor #throttlebody #soldering
#solenoid
Distributor oil seal change
• DIY: HOW TO REPLACE #M...
Detail on Mass Airflow sensor MAF
• Mass Air Flow Sensor: ...
Detail on Throttle position sensor TPS
• Throttle position sens...
Detail on IDLE CONTROL Valve IAAC FICD
• Idle Control Valve:Und...
Detail on Cleaning Hot Wire of Throttle body MAF sensor
• How to clean dirty Mas...
Detail on Solenoid starter armature winding check
• Car Solenoid Starter D...
#sajalazlanesh
Негізгі бет Pro Tips: Resoldering Nissan
Пікірлер: 12