Dang, that's a lot of bling under the hood! Linkage setup looks good. Nice and clean.
@OpossumWorks
2 жыл бұрын
I did avoid chrome wherever possible, brushed aluminum is harder to avoid.
@TheWolfMatt
2 жыл бұрын
Looking pretty good so far bud. I'd end up using a Kevlar tube to run those electrical cables through from under the intake manifold. Those will get incredibly hot down there and you don't want to roast any of those connections/wires routed through there. Really enjoying the build though. Can't wait to see this beasty running soon.
@OpossumWorks
2 жыл бұрын
I figured it would be warm under there but didn’t think it would get melt wire hot. I may have to apply some heat tape to the valley cover, there’s just too much wire done there going every which way to sleeve it all.
@TheWolfMatt
2 жыл бұрын
@@OpossumWorks You could wrap them in header tape if you can't sleeve them. Keeps them very well insulated against the heat.
Пікірлер: 6