To test Resistance, put the meter on Omega at 20k. Red on PIn 1 Black on Pin 2 To test continuity: Put the meter on Continuity and test between 1 and 3 then between 1 and 2.
@paryk144
Жыл бұрын
What resistance should be for a faulty and working sensor?
@hanynowsky
Жыл бұрын
@@paryk144 something like at least 600omega for a working sensor.
@NachDiktatVerreist
5 жыл бұрын
if this are 3 pin sensors: i think on pin 1 + 3 (12V and ground). Pin 2 is the signal wire.
@brianwildgoose6454
5 жыл бұрын
Ok but where are you touch on the sensors ?.
@longhuynh5249
Жыл бұрын
A discount price that end up being more expensive.
@Tahsin_Hussain
3 жыл бұрын
First you need to tell the viewers, which settings did you use in the MULTIMETER. Are you checking the CONTINUITY or the RESISTANCE or Something else? Possibly he don't know what he is doing?
@Dorout
5 жыл бұрын
On which pins do you measure on? It would really help me. Thanks
@hanynowsky
Жыл бұрын
Red on PIn 1 Black on Pin 2
@tommy900motor
2 ай бұрын
😂😂😂😂😂😂 did it the wrong way round
@Hutchy45445
4 жыл бұрын
Are you testing Ohms?
@rondail5675
2 жыл бұрын
The meter seems to be set to 'Continuity', diode testing.
Пікірлер: 12