Great!!!!!!...... So informative hope u will discuss various troubleshooting topics in future...👍👍👍👍
@elivalderrama1
2 жыл бұрын
Thanks! Hello maybe you can answear this question for me. what can cause the cure time from not stopping at its set point.?
@Engelglobal
2 жыл бұрын
Dear Eli Valderrama, not sure about your question, could you clarify it a bit?
@govindraj4976
2 жыл бұрын
Dear Sir, Thank you, what is the purpose non - return valve? Please tell me.
@Engelglobal
2 жыл бұрын
The purpose of the non-return valve is to allow the metering of material to the front of the screw during plasticizing. It also doesn’t allow the back flow of material down the screw during injection.
@ramphaluttam7171
3 жыл бұрын
Good after noon sir..what is back pressure of 3/4 INCH NRV of steel
@Engelglobal
2 жыл бұрын
Dear Ramphal Uttam, do you mean ¾ inch is the barrel diameter? In general it depends on material and screw design. Also mixing any additives into the material (colorant, uv stabilizer, plasticizers) makes a difference. Could you perhaps clarify your question a little?
Пікірлер: 7