To program a Somfy louvered roof circuit board using the Telis Remontrol and the programming buttons S1 and S2, follow these additional steps:
Select the channel on the remote that you want to program.
Press the program button on the circuit board until the S1 light turns yellow.
Press and release the up and down arrow on the remote (make sure you are on the channel you want to program on the remote). This press and release of the up and down arrow will make a slight jog motion on the motor, which indicates that it is ready for programming.
Press the up arrow to test the direction. If the louvers open, it is correct. If they close, press and hold the MY button until you get a jog in the motor. This will reverse the direction. Test again.
Press and release the up and down arrow at the same time. This will start the motors running to the open and closed position on their own (this is finding its upper and lower limits, in other words fully open and fully closed). You don't need to do anything until it finishes both directions on its own.
Once this is complete, press and hold the MY button until you get a jog.
Turn the remote over and press and hold the small button on the back of the remote with a paperclip until it jogs again. You are now done.
REMINDER: repeat for s2 for second motor.
FYI up arrow opens louvers, down arrow should close louvers and the MY button can stop louvers in any position.
Негізгі бет Programing Motor Somfy Circuit Board Apollo Louvered Roof motorized pergola
Пікірлер