Amazing to see her up & running!!! I'm seriously considering doing a uk 106 fwd evo build using a donnor lancer 4! I'm a mig welder by trade & believe it possible to dissect both cars, shorten the evo chassis then re-weld to size ready to drop the hollowed out 106 shell bk on top! Then more welding!
@Aaron-ft4vm
10 ай бұрын
Sounds fantastic. Can't wait to hear it at full chat! Welll done!!
@scattkiwiman
10 ай бұрын
well done ! sounds good too. There's a lot to monitor at first starts ...warmup cycle, idle warmup cycle, afr, water temp, oil temp/press., but you'll get used to that. Just be sure to never have it too lean. if you're working alone think about making a relay system that shuts the thing down when oil press drops or water temp too high. (of coarse not for road use :-)
@henrikcarlsen1881
10 ай бұрын
4:30 it's a simple stitch remover tool. They are handy for tape and crimp ... and stitches.
@JMcKaySV
10 ай бұрын
Nice work mate. Looking good
@InfinityCharm
10 ай бұрын
Very nice 😮
@jaybradley3765
10 ай бұрын
Great work 🎉
@KobiGamez
10 ай бұрын
Loving this project, I have a VTR but ngl I'm so new to cars i like checking here to see how to do basic shit that i can't do because saxperience is a minefielcd lol
@MaXpeedingRods_Coop
10 ай бұрын
keep your work , hope sponsor
@vasilqnev3730
6 ай бұрын
Hi, i am in the process of installing same type race alternator, can you help me with 2 pins wiring, because i only have one cabel for battery positive and one more for light dash
Пікірлер: 10