Those are the cleanest turn signals. I just got done recording a video doing this on an early Dyna. I had to dig the the wires through the frame and de-pin the hand control connectors. Used some string, tape and a vacuum to pull the wires through T Bars. Also filed down the clutch perch and master cylinder assembly to allow for internal routing of the turn signals. Really glad I watched till the end, Im going to have to get those mirrors.
@mikeessary4925
3 жыл бұрын
Great choice!! I'm looking forward to a walk-around
@bmxguy148
3 жыл бұрын
I wasn’t able to catch what length the upper brake cable and clutch cable length you guys used.. I just ordered those risers in a 10” & the moto bars and you guys figured out the perfect length already
@PutMilesOnIt
2 жыл бұрын
I think I just found my new favorite channel
@AnthonyTrackStar
3 жыл бұрын
You could just switch the upper clutch cable with new softail models
@scottdonbrosky5968
3 жыл бұрын
I have the exact same color of bike and exact same Krause bar / Krause 6” straight riser/ hart grip set up. Only difference I did were Rizoma mirrors and custom dynamics led lights. FYI. Harley has a huge option of the 2 piece clutch cable. Easy as cake.
@bajamedic
2 жыл бұрын
How much riser could you do without extending the clutch and brake line?
@meanf1502
4 ай бұрын
Was it a pain to remove the reflectors on the fork tube I need to remove mine nice project bike have a 2020 low rider s
@robbyclark6915
2 жыл бұрын
With the way Harley does their clutch cables now, why can’t you just replace the top portion of the cable (disconnect at the little plastic thingy) to accommodate the extra height vs replacing the entire cable?
@jeffsaba7602
Жыл бұрын
Great Vid! What riser bushings did you go with (poly). There are so many to choose from 😐
@djjstatus
2 жыл бұрын
Clean setup bro…gonna go the same route…mind giving me the size brake line and clutch cable u used??? Thanks bro!!!
@mrshovelhead5096
Жыл бұрын
i need the size as well
@andrewshortt5
2 жыл бұрын
What size risers are those?
@Tailgatejoe
3 жыл бұрын
great video. Any specs/info on the nylon wire loom you used? Diameter, where you purchased, etc.
@IronAnchorCycles
3 жыл бұрын
It's 1" braided nylon. You can get it on Amazon...
@TickTownProductions
12 күн бұрын
What are the benefits of replacing the top tree with the bars and risers
@IronAnchorCycles
12 күн бұрын
This is a lot more than just replacing the top tree - check out the previous video for more info on the front end.
@skulldaddy8431
2 жыл бұрын
Got my kit from Krauss. Trying to run wire and there are only two small holes at exit on each side (where the wires come out to connect to bike). I noticed that your bars have a larger hole in the center where the wires come out. Did you have to machine that? It looks like if I run the wires to the holes I have they will be covered by the bottom of the riser. Please advise
@Wild-Wisdom
Жыл бұрын
I'm still waiting on the cruise control I ordered for my 21 fxlrs in December of 21, it's March of 23 and still hasn't shown up yet. Unbelievable
@itzmurphylee
2 жыл бұрын
So instead of a +6 (the difference between stock bar/riser setup) you went with +4 magnum clutch and brake cables?
@brianheppner1725
2 жыл бұрын
I have a 2021 Harley Davidson Low rider S in which I am doing the exact same setup What was the exact length of Clutch cable and Upper and lower Brake lines that you ordered from Magnum? Any Info you could give me would be greatly appreciated
@andantlu8925
Жыл бұрын
What exactly are the brake and clutch lines that you have i have 21 fxlrs and im lookin to raise my bars but im not sure what to buy on magnum shieldings site i have 6.5” risers with 1.5” pullback i just dont know what to buy and would rather have to order it once instead of twice
@sammyvices2547
Жыл бұрын
Is 04-21 XL the correct turn signal LEDs for a 2022 fxlrs?
@raymondraymondjr6463
2 жыл бұрын
What’s up boss great build .. I got a question I bought some sport glide bags for my low rider s 21 but I don’t have keys to the locks .. where could I get new locks and keys for bags ? And I also need the small mounting bushing that attaches to the bottom of frame and to saddle bag supports where would I get that also ? Any info would help thanks pal
@chilldbox
Жыл бұрын
Have 2 get them from harley.
@ryant3694
2 жыл бұрын
Which turn signals do I need for a '20 fxlrs?
@erikmorales7612
2 жыл бұрын
Great video man! If for some reason the risers or slightly crooked. How do you fix that?
@IronAnchorCycles
2 жыл бұрын
Just loosen the riser bolts and straighten them out - then tighten. There's play in there, so they can go on crooked if you don't line them up. Good luck with it!
@erikmorales7612
2 жыл бұрын
@@IronAnchorCycles thanks I did that and also loosed the clamp bolts. They lined up I just had to move the bar a little over to the left.
@paulson9616
Жыл бұрын
Excellent vodeosnd thank you. As far as bar concerns, you mentioned this moto bar is from kraus. I know kraus does not produce but uses other brands as supplier. Do you know what brand this bar is? It looks so sick!!!
@mikeessary4925
3 жыл бұрын
Can heated grips and cruise control be added to this bars and risers set up? Thanks
@IronAnchorCycles
3 жыл бұрын
Cruise control yes, heated grips are not compatible with the FM bars.
@mikeessary4925
3 жыл бұрын
@@IronAnchorCycles oh noooo!! Do you know of a similar bar that can have heated grips?
@bmxguy148
3 жыл бұрын
@@mikeessary4925 I believe you can just drill and notch a hole where you need for them
@abrahamperez9369
3 жыл бұрын
Where are you guys located??
@IronAnchorCycles
3 жыл бұрын
New York
@abrahamperez9369
3 жыл бұрын
How much would a job like that would cost
@IronAnchorCycles
3 жыл бұрын
Give us a call or send an email - info@ironanchorcycles.com or 845-363-1566
@Lefty-uj4rt
2 жыл бұрын
Take a shot every time he says “uh/um”
@IronAnchorCycles
2 жыл бұрын
Cool… drink up then.
@gregb6888
4 ай бұрын
Drunk quick 🎉
@SmittyTuck
Жыл бұрын
Love your videos my dude, this one was extremely difficult to watch with the excessive uh and umms Thanks for all the great content but please pretty please clean up the uh and umms 🙏
@amg5795
2 жыл бұрын
Watch all video and you never mentioned what high is these risers! Come guys seriously…
Пікірлер: 48