Mike Broadhurst lol, Mark is gonna love you. Great vid By The Way 👍🏻
@Best2Strokes
4 жыл бұрын
Very nice bro 😀❤️
@TheSteelweasel
4 жыл бұрын
dont leave the seals in the sealed bearing . by doing this you stop lubrication on the back edge of the drive side bearing seal and it then fails and sucks oil in from gear box . i also thought it was a good idea years ago but soon found it was a mistake ..... nice work .
@philipshanks2367
4 жыл бұрын
Why is it, the interesting and clever youtubers get such low views? This channel is clever..
@davidblagden7894
4 жыл бұрын
Very informative, great to see new vids being made. keep up the good work. cheers
@infernalcontraptions
4 жыл бұрын
Just brilliant. Thank you.
@greggullotta2870
2 жыл бұрын
great video
@shaundewar7397
4 жыл бұрын
Again a great vid, very instructive and really good camerawork.
@paulstephans3364
4 жыл бұрын
Superb video's very useful 👍
@chris_debian5368
Жыл бұрын
Thanks for the great video. On the 'outro' credits, should it say 'Lincoln.....' rather than 'Licoln....'? Cheers, Chris.
@dungcao5958
2 жыл бұрын
admire you.
@annoyin_cnt291
3 жыл бұрын
Been watching your build videos from the start very good. How much was the TDC Tool and where from? looking forward to watching the rest of the build thank you.
@siddukundapur9737
3 жыл бұрын
👍👍👍
@swassige
3 жыл бұрын
So how did you get the cylinder studs to stop leaking???
@732kustoms4
3 жыл бұрын
Nothing to clever, I just had to strip the whole lot down (again) clean off the sealer then build the whole thing back up again only this time making sure to get a good bead of sealer around all the studs. On the packer plate I hadn't gone all the way round the studs on one side.
@swassige
3 жыл бұрын
@@732kustoms4 incredible amount of work just for that alone, I feel your pain!
4 жыл бұрын
Goob job! :) Keep it up! Would you like to be KZitem friends? :]
Пікірлер: 18